Size of porthole hole on 4 + 2 Help someone must know !

Thoughts, Ideas and General Questions
aggalletley
Posts: 63
Joined: Fri Feb 24, 2012 4:44 pm

Size of porthole hole on 4 + 2 Help someone must know !

Post by aggalletley »

Still trying to find out the size of the hole if you remove the portholes on a 4 + 2. Somone must have replaced theirs sometime. Seems that if I take the outside surround off it will break so would like to buy the replacements before I start the job. E mailed Shetland Boats...no reply of course.
My old port holes have perished and are the only thing letting down my beautiful 22 year old Shettie
Once I know the size of the hole can order replacements
Andrew
daveflack
Posts: 291
Joined: Fri Nov 08, 2013 6:54 pm
Location: Black Hawk "Atlast"Ullswater, now a 4+2

Re: Size of porthole hole on 4 + 2 Help someone must know !

Post by daveflack »

Hi there sorry for the late hour,the outside ring does not normally come of until the inside ring is removed.The outside ring is normally flanged to go thro' the hull & prevent leaking.Thus,the inside ring slides over the flange aligning with the securing screws,so if you can see this join inside the boat measure the outside diameter of the flange tube & you will be near enough the size of the hole,(its a bit like a washer over a bolt).If you use a very sharp fine blade & remove as much sealant as possible from around the tube & then under the outside flange it will help limit damage. Hope this makes sense & a bit more of a help than those who shall remain "nameless".Cheers Magicflack