Tidying up interior window fixings/nuts/surrounds?

Thoughts, Ideas and General Questions
ChrisC
Posts: 14
Joined: Thu May 10, 2018 2:24 pm

Tidying up interior window fixings/nuts/surrounds?

Post by ChrisC »

Hi,

Has anyone found a good way to tidy up the interior window trims in the cabin? I'm referring to where the earlier boats with oversized windows held with screws and nuts are fixed. On ours, (a 1989 4+2) the edge of the of the grp (as covered in lining material) is basically raw. I'd like to make this look a bit neater.

Thanks.

Chris
daveflack
Posts: 291
Joined: Fri Nov 08, 2013 6:54 pm
Location: Black Hawk "Atlast"Ullswater, now a 4+2

Re: Tidying up interior window fixings/nuts/surrounds?

Post by daveflack »

Hi there, had a similar problem on my Black Hawk, it looked awful. My eventual solution was to get some white plastic angle from a local double glazing fitting Co'. I think it was about 60mm wide X 2mm thick. It was then a case of cutting one side down to match the distance from carpet surface to the glass & then marking of the centres of each hole (I did this incase the holes where not uniform on each window). Once this was done I then overlaid each piece to mark off the corner angles so it all mitred together. A long winded job, nearly 200 holes in total but I thought it worth the effort & kept me busy during the winter. Cheers Magic.
User avatar
Freebird19
Posts: 79
Joined: Tue Jan 12, 2016 5:57 pm
Location: Black Hawk "Freebird" Norfolk

Re: Tidying up interior window fixings/nuts/surrounds?

Post by Freebird19 »

Any chance of quick photo of yours Magic?
daveflack
Posts: 291
Joined: Fri Nov 08, 2013 6:54 pm
Location: Black Hawk "Atlast"Ullswater, now a 4+2

Re: Tidying up interior window fixings/nuts/surrounds?

Post by daveflack »

Hi there this is the only pic I have at present but it gives an idea as to what I did https://photos.google.com/photo/AF1QipN ... WOAqjzFzTu hope this works
User avatar
Freebird19
Posts: 79
Joined: Tue Jan 12, 2016 5:57 pm
Location: Black Hawk "Freebird" Norfolk

Re: Tidying up interior window fixings/nuts/surrounds?

Post by Freebird19 »

Thanks Magic. The link is broken but don't panic. I think replacing my cabin lining is some way off!
Franknstein
Posts: 35
Joined: Tue Jan 19, 2016 8:24 am

Re: Tidying up interior window fixings/nuts/surrounds?

Post by Franknstein »

Heya, I'm not sure if this is relevant, but I just did this job this weekend. I used electrical conduit. 25mm x 10mm? I think. The cover plate simply snaps on/off to reveal the nuts behind. I also drilled countless holes so the full nut can go through the holes. They're double sided taped on for now, but I think I might need to think of a better way of attaching them. My plan is to cover the cover panels with wood effect vinyl - don't know how long the vinyl will last but my boat sits under a cover most of the year.
Here's a pic.
You do not have the required permissions to view the files attached to this post.