New Houdini hatch

Thoughts, Ideas and General Questions
kevin1234
Posts: 9
Joined: Sat Oct 06, 2018 6:30 am

New Houdini hatch

Post by kevin1234 »

HI

We need to replace the Houdini on our Shetland 4+2 does anyone know a trusted person who could fit a new one? We are on the Medway

Thanks Kevin
ChrisC
Posts: 14
Joined: Thu May 10, 2018 2:24 pm

Re: New Houdini hatch

Post by ChrisC »

Hi,

I've just replaced the hatch on our 4+2, it's not too tricky a job.

Ours was riveted in so I had to drill them out first. Then the sealant was quite firm so I had to slowly work around with a paint stripping knife and break the seal to lift the old one out. A good go with a strong plastic scraper and some white spirit got the surface clean. Then the new one was dropped in. The holes were in slightly different places so I drilled new ones. I used the non-setting mastic which Houdini recommend after masking around the hole to minimise the mess. Dropped it in and used stainless countersunk machine screws which I got from Screwfix.

I'm on the Medway too - Medway Wharf Marina in Nettlstead/Watteringbury. I'd be happy to give you any other pointers if I can help.

Chris
kevin1234
Posts: 9
Joined: Sat Oct 06, 2018 6:30 am

Re: New Houdini hatch

Post by kevin1234 »

Hi Chris

Thank you for your response I'm at Twyford Marina so I could pop over to see at yours when you are around. My contact number is 07799 357 879

BW

Kevin