Hi all,
New to this forum so forgive ignorance of past info.
I have ,and love to bits, a Shetland family 4 - 2007 build and am struggling to make sense of all the water that appears to be collecting below cockpit floor,it is coming up through the cockpit seat base where it is screwed to the cockpit floor.
I have some leakage in cabin too,guess that is window seals, but cannot figure how the space between the outer hull and superstructure could become so wet.
Any ideas? do i need a bilge pump or can i source the areas where it is coming in and seal it?
Thanks
Tony
family 4 water ingress
-
dellquay13
- Posts: 556
- Joined: Tue Mar 15, 2011 7:45 am
- Location: Pequod, F4 mk4, Milford Haven Marina
Re: family 4 water ingress
Hi Tony,
F4s have always been a bit prone to leaky cabin windows, which let a surprising amount of water get under the cabin and cockpit floor. Later models have suffered from screws, nuts and bolts not being tightened properly from the factory, and older boats may have cracked or crazed windows. There is a small drain hole low down at the back of the sump below the engine splashwell on earlier F4s which is enough to drain small amounts of water that may get in, but I haven't seen inside a later model like yours. If you are flooded up to the floor level you may need to pump out bit by bit through any holes you have in the floor for table or seat bases. There are lots of threads about this subject to search for further advice.
Hope this helps,
Chris
F4s have always been a bit prone to leaky cabin windows, which let a surprising amount of water get under the cabin and cockpit floor. Later models have suffered from screws, nuts and bolts not being tightened properly from the factory, and older boats may have cracked or crazed windows. There is a small drain hole low down at the back of the sump below the engine splashwell on earlier F4s which is enough to drain small amounts of water that may get in, but I haven't seen inside a later model like yours. If you are flooded up to the floor level you may need to pump out bit by bit through any holes you have in the floor for table or seat bases. There are lots of threads about this subject to search for further advice.
Hope this helps,
Chris
I have now sold my 1989 F4 mk4, 2015 70hp 4str Yamaha. Milford Haven. I proudly owned it for over 20 years, before changing to sailpower and a yacht...