Hi,
I am considering to strengthen the stern of my boat, as I have seen a few cracks around the (inboard) engine bed. It started with that the boat (before I bought it) has been standing on a trailer unattended, and at winter some water gathered in the rear of the boat, which frooze and caused cracks where the water expanded. I have cut away all the broken plastic and fibreglass, to reveal the wooden frame that holds the engine. The wood itself is still solid, so I will keep that, but I want to add material (wood or iron) to strengthen the existing "frame", before I replace the fibreglass and epoxy resin.
To make the area sturdier I would like to see a drawing of the boat, to find "connection points" and generally how the boat is built.
Can anyone tell me if there are drawings available for Shetland 570, and in such case, where I can find/order them?
Best regards //
Magnus
Drawings for Shetland 570
-
daveflack
- Posts: 291
- Joined: Fri Nov 08, 2013 6:54 pm
- Location: Black Hawk "Atlast"Ullswater, now a 4+2
Re: Drawings for Shetland 570
I doubt you'll get any official results, Shetland keep their dwgs under lock & key, but you might get a reply from a member whose done a similar repair. If you are going to reinforce an area DON'T use iron it will rust & burst the fibreglass. Cheers Magic.
-
dellquay13
- Posts: 556
- Joined: Tue Mar 15, 2011 7:45 am
- Location: Pequod, F4 mk4, Milford Haven Marina
Re: Drawings for Shetland 570
I believe the 570 evolved into the black hawk and then the Kestrel in the 1980s. The black hawk and Kestrel were offered as an inboard motor variant. Your 570 inboard may be an early trial version, a bit like a concept car.
Quayline boats in Poole bought the mould tools for the black hawk from Shetland back in 2018, and most likely got the plans too, if Shetland still had them, after changing ownership themselves several times.
Some forum members have previously said that Quayline ceased trading a few years ago when the owner died, so this might be another cul-de-sac.
Quayline boats in Poole bought the mould tools for the black hawk from Shetland back in 2018, and most likely got the plans too, if Shetland still had them, after changing ownership themselves several times.
Some forum members have previously said that Quayline ceased trading a few years ago when the owner died, so this might be another cul-de-sac.
I have now sold my 1989 F4 mk4, 2015 70hp 4str Yamaha. Milford Haven. I proudly owned it for over 20 years, before changing to sailpower and a yacht...
-
dellquay13
- Posts: 556
- Joined: Tue Mar 15, 2011 7:45 am
- Location: Pequod, F4 mk4, Milford Haven Marina
Re: Drawings for Shetland 570
Try changing the title of your question to something like 'inboard 570, black hawk or kestrel', and it may attract owners of the later boats who have more info on the internal layout of the inboard variant, but are not aware of the connection of their boat to a 570.
I have now sold my 1989 F4 mk4, 2015 70hp 4str Yamaha. Milford Haven. I proudly owned it for over 20 years, before changing to sailpower and a yacht...