Hi Everyone
Does anyone know the type of bolt/bracket required to fit my remote steering to the outboard?
I tried a standard bolt and boat only steers one way,
Am I right to think that this will be some sort of “L bracket” to prevent steering bar clashing with outboard bracket?
Thanks,
Remote steering bolt
-
DaveClark
- Posts: 61
- Joined: Mon Apr 05, 2021 6:59 am
Remote steering bolt
You do not have the required permissions to view the files attached to this post.
Shetland 535 9.9hp outboard
-
Clive
- Posts: 548
- Joined: Sun Jun 23, 2019 8:41 am
Re: Remote steering bolt
This is on mine - a simple bracket on to which is bolted an arm. My engine has power tilt which the steering cable passes through. Hope this helps, and hope you can work them out!
You do not have the required permissions to view the files attached to this post.
4+2 (1988) 35hp Honda outboard, currently in a field outside Horsham.
-
DaveClark
- Posts: 61
- Joined: Mon Apr 05, 2021 6:59 am
Re: Remote steering bolt
Nice one Clive
My bracket on outboard is different, I’m sure I can make something up to suit.
My bracket on outboard is different, I’m sure I can make something up to suit.
Shetland 535 9.9hp outboard
-
Clive
- Posts: 548
- Joined: Sun Jun 23, 2019 8:41 am
Re: Remote steering bolt
Yes thought so. At least you have an idea now.
4+2 (1988) 35hp Honda outboard, currently in a field outside Horsham.
-
dellquay13
- Posts: 556
- Joined: Tue Mar 15, 2011 7:45 am
- Location: Pequod, F4 mk4, Milford Haven Marina
Re: Remote steering bolt
There will be a bespoke bracket, with a shouldered and threaded vertical pin for the steering rod, and it will fit to the keyhole slot on that handle looking part of the outboard. It is usually set up to have the steering rod offset and horizontal, and the rod is not clamped tight, there is a little play to allow for rotation as the engine pivots. It will have the steering rod either above or below the plane of the handle bracket, to allow the engine to swing without having the rod too far out from the engine pivot point. The closer the rod connection point is to the pivot point, the less travel is needed for lock to lock (but with more lateral swing of the rod as the engine pivots).
I have seen some made by the engine manufacturer, some generic ones in chandlerys and some perfectly good homemade ones.
I have seen some made by the engine manufacturer, some generic ones in chandlerys and some perfectly good homemade ones.
I have now sold my 1989 F4 mk4, 2015 70hp 4str Yamaha. Milford Haven. I proudly owned it for over 20 years, before changing to sailpower and a yacht...
-
dellquay13
- Posts: 556
- Joined: Tue Mar 15, 2011 7:45 am
- Location: Pequod, F4 mk4, Milford Haven Marina
Re: Remote steering bolt
https://www.ebay.co.uk/itm/262492568200 ... SwM4xXaTpz
Here's a generic one, it would need a stainless bolt and washers to connect the steering rod.
Here's a generic one, it would need a stainless bolt and washers to connect the steering rod.
I have now sold my 1989 F4 mk4, 2015 70hp 4str Yamaha. Milford Haven. I proudly owned it for over 20 years, before changing to sailpower and a yacht...
-
DaveClark
- Posts: 61
- Joined: Mon Apr 05, 2021 6:59 am