How did the colour turn out on your boat? I have had my hands full with the electrical stuff, so I have not started on the outside. In theory I should have the same colour code as you had. Do you mind sharing it?
Best regards //
Magnus
Clive wrote: Tue Apr 06, 2021 10:22 am
I’ve got mine arriving today - East Coast do colour matched fibreglass as well as GRP filler. I’ll let you know how it compares to the boat (off white, not turquoise).
Hi - after three attempts I got a close match, which works for my grp. I think it might be close to the original as looking at different sections of the boat, the colour is consistent and having cut back some with wet n dry to remove stains, the colour is the same.
The first picture shows the repair to the corner that was bare fibreglass, then moving forward, a spider crack as a result. You can hardly see, but there are 4 bubble marks to fill, just to make sure no water can get in over long term which I'll fill when mix some more grp..
The second picture showsdarker patches which are filled screw holes which is a RAL colour. These will be under the fender when I replace it. You can just about make out the repair where the control cables came through the transom - I'm very pleased with this result and it's GT600 Brush Gelcoat (from East Coast Fibreglass Supplies ECF again).
The third picture shows similar screw hole damage repair and above repaired gouges and deep scratches, below I cleaned out a cracked earlier repair and re-did it. Got plenty more little bits and pieces, and some more spider cracks.
ECF are really helpful and do repair kits as well.
Plenty to do as usual!
You do not have the required permissions to view the files attached to this post.
4+2 (1988) 35hp Honda outboard, currently in a field outside Horsham.