Engine jobs
-
Clive
- Posts: 548
- Joined: Sun Jun 23, 2019 8:41 am
Engine jobs
I’m committed now! After use on the River Wey, basically trolling for hours on end the engine started running a bit lumpy. Ran some Sea Foam through which helped and did a compression test recently which is fine so thought I’d do a deep clean of the carbs. So far out of my comfort zone I’ve photographed every step, labelled and laid out the parts in order! All seems quite clean so hope there’s an improvement.
You do not have the required permissions to view the files attached to this post.
4+2 (1988) 35hp Honda outboard, currently in a field outside Horsham.
-
Clive
- Posts: 548
- Joined: Sun Jun 23, 2019 8:41 am
Re: Engine jobs
Update - fortunately before I put it all back I read the slow running jets are prone to hairline cracks which are difficult to see with the naked eye. I had a look using my iPhone and sure enough one was cracked. Eventually sourced a replacement - well two as that was all I could get. Then found the engine oil was right at the top of the dip stick tube. Got advised it was fuel in the oil from a split fuel pump diaphragm. No parts for my model so got a new pump. Put it all back, new oil and filter and it started first time and sounded great. Bought a carb synchroniser to get the triple carbs balanced after I’d tuned them. Looking forward to getting on the water to compare with previous.
4+2 (1988) 35hp Honda outboard, currently in a field outside Horsham.