New to me 570
-
Ozi
- Posts: 24
- Joined: Fri Dec 09, 2022 9:20 pm
Re: New to me 570
At home for a refresh.
You do not have the required permissions to view the files attached to this post.
-
Ozi
- Posts: 24
- Joined: Fri Dec 09, 2022 9:20 pm
Re: New to me 570
A marine electrical trader near to me has done his boat like this . It looks cool to me any thoughts lads.
You do not have the required permissions to view the files attached to this post.
-
vreagh
- Posts: 327
- Joined: Sat Aug 02, 2014 5:46 pm
- Location: Cornwall
Re: New to me 570
Certainly looks neat and tidy. You would have to adapt it to suit your own needs though. Don't forget that the battery box needs venting overboard by a rising vent ( gasses are lighter than air and highly explosive).
-
Clive
- Posts: 548
- Joined: Sun Jun 23, 2019 8:41 am
Re: New to me 570
Looks good, but a lot more complex than you would need for your boat. Personally I would insist all positive bus bars (where multiple cables are connected) have a cover. The possibility of dropping a screwdriver or similar and creating a short is too risky! Also, make sure the positive cable from the battery is fused within 100mm (4ins). All fuses are to protect the cables from overload which equals heat which may cause a fire. You don't want that!
4+2 (1988) 35hp Honda outboard, currently in a field outside Horsham.
-
Ozi
- Posts: 24
- Joined: Fri Dec 09, 2022 9:20 pm
Re: New to me 570
Thanks lads , all good info and much appreciated . I plan to visit the other boat to get a sense of the two installations. 3D printed a sketch of my car next is the 570.
You do not have the required permissions to view the files attached to this post.
-
Ozi
- Posts: 24
- Joined: Fri Dec 09, 2022 9:20 pm
Re: New to me 570
I have the floor up and out of the boat and this reveals the ribbed structure and separate but linked bilges . In a few places there is a bit of movement if you press between the ribs by the floor edge . I guess I am pressing down to the floatation foam . Is this normal and do I need to fill up this space with builders foam or a specific boat equivalent ?.
-
Ozi
- Posts: 24
- Joined: Fri Dec 09, 2022 9:20 pm
Re: New to me 570
Is there a picture of a cross section of my 570 please?.
-
Clive
- Posts: 548
- Joined: Sun Jun 23, 2019 8:41 am
Re: New to me 570
Not from me I’m afraid! Where you say it is soft, what is? The foam? More important, is it wet. Any foam you replace need to be closed cell foam, otherwise it will soak up water like a sponge. A picture would help lots of people have rebuilt the floor on these.
4+2 (1988) 35hp Honda outboard, currently in a field outside Horsham.