Hi all
i have a shetland speedwell i purchased earlier this year and have made some significant alterations to the deck area but they are balanced in terms of weight distribution.
whist all of the seating etc was removed i discovered i had a list to stb'd of a few degrees ( about 2'' at the stern waterline).
all that remained was the 12 v battery in the stb'd well at the rear and the portapotty stbd side in the cabin.
Since it took a full water tank , and a 25 litre water tank and a 20 litre fuel tank stowed port side ( approx. 60 KG of weight ) to bring the list almost under control i am concerned i have water ingress.
There is a cut out in the rear cockpit for a table support and removed i can see into the hull which is bone dry.
i know there are webs every 40 cm along the hull for strength and i can see no further than this.
so my questions are
1. does water in the hull flow to the bottom of the V of the hull and therefore only affect the displacement of the hull
2. if so will it flow back into the stern when the bow comes up out at higher speeds or do the webs completely section the hull
3. if water can collect in one side of the hull what is the best method for identifying its location i have no inspection holes in the cabin
4. is this likely to be just a trim issue ?
many thanks
carl Cameron
Spring tide
St Olaves Marina
Speedwell listing
-
norfolkspeedwell
- Posts: 1
- Joined: Sat Mar 17, 2012 5:18 pm
- Location: ST Olaves Norfolk