Black Prince planeing

Thoughts, Ideas and General Questions
Neil
Posts: 13
Joined: Thu Jun 14, 2012 12:08 pm

Black Prince planeing

Post by Neil »

Hi all
Still having problems getting my Black Prince up on the plane.
She is fitted with a Volvo 140 HP petrol engine, and a Volvo 280 stern drive, but does not have trim tabs.
She runs 'dug-in' at about 9-10 knots, with the engne running at 4000 revs, but is reluctant to rise !!!!
We managed to get her 'planeing' breifly at 17 knots, by one of us going up to the bow to add some weight; but there must be a better solution.
Does anyone know anything about 'Doel-Fin hydrofoils' that bolt onto the stern-drive cavitation plate, and would they be worth trying????
Any ideas greatfully accepted.
Neil
dellquay13guest

Re: Black Prince planeing

Post by dellquay13guest »

Hi,
You say you don't have trim tabs, but can you raise and lower the lower leg? Try trimming the leg down to it's lowest and give it full throttle until you climb over the hump and level out, probably at about 17mph, then trim back up bit by bit until you start 'porpoising', and then trim back down a bit and drop revs a bit to the speed you want.
Doel fins work ok on heavy boats with undersized outboards in the 30-90hp range, by giving extra stern lift, just like you get by trimming fully in, but cause drag and lose a bit off the top speed, and should be a last resort.

Hope this helps,

Chris
Neil
Posts: 13
Joined: Thu Jun 14, 2012 12:08 pm

Re: Black Prince planeing

Post by Neil »

Hi Chris
Thanks for your response.
The leg is fully down when I am trying to get her up on the plane, but she just does not want to get 'over the hump' as you put it.
I just thought that a fin would help lift the back end?
Neil
Dellquay13guest

Re: Black Prince planeing

Post by Dellquay13guest »

Hi,
A few last things to check before you shell out forty quid for doel fins are checking your weight distribution fore and aft, and the old chestnut of the correct pitch for your prop.
When I have 80litres or more of fuel on board my F4, I have to store half well forward in the cabin and a jerrycan in the anchor locker to keep the balance right, and I only have a very light 2 stroke outboard and only 2 adults at the midship helm when planing, nothing like the weight at the rear of the big inboard and outdrive that you have.
I guess that 4000rpm is about the max that an inboard is expected to give, unlike an outboard at 5500rpm, so your prop is probably pitched ok.

Chris
dellquay13
Posts: 556
Joined: Tue Mar 15, 2011 7:45 am
Location: Pequod, F4 mk4, Milford Haven Marina

Re: Black Prince planeing

Post by dellquay13 »

... Saying all that, my outboard needs it's doel fins to stop me having to use loads of trim all the time... I was just trying to save you the cost and inconvenience of having to fit them too.

Chris
I have now sold my 1989 F4 mk4, 2015 70hp 4str Yamaha. Milford Haven. I proudly owned it for over 20 years, before changing to sailpower and a yacht...