535 bows u bolt fit

Thoughts, Ideas and General Questions
netsman
Posts: 3
Joined: Tue Jul 31, 2012 11:18 am

535 bows u bolt fit

Post by netsman »

Hello from the Fens of Norfolk/Cambs border, just joined & pleased to have found you all. Always had my boat moored on water - never needed to trailer. Bought a neat 535 off the Norfolk Broads & a trailer in seperate purchases & have just realised the 535 doesn't have a U bolt in the bows. My previous cruisers have all been wooden & I've not worked with a 535 or GRP before. I only saw the 535 for about 10mins, fell in love with it & all common sense questions & observation went out the window! I've done most DIY jobs on my other boats but can I easily & safely fit the U bolt. If you answer, thank you very much & please assume my total ignorance re 535s & GRP...
User avatar
Coddy
Posts: 96
Joined: Thu Sep 01, 2011 3:51 pm
Location: Dorset

Re: 535 bows u bolt fit

Post by Coddy »

HI and welcome to the forum

Your U bolt is an easy fit, however, I would recommend that you add a bit of reinforcement, wood, in the inside of the V of the hull to help spread the load when you winch the boat onto a trailer etc.

Do use a stainless steel U-bolt designed for the job as I have seen a few that just bent under the pressure.

Oh, need a steady hand to drill the holes in the bow and don't forget to seal it with Stikaflex to prevent water ingress.

Have fun

Dave
8-)
netsman
Posts: 3
Joined: Tue Jul 31, 2012 11:18 am

Re: 535 bows u bolt fit

Post by netsman »

Dave, thanks for the input re the U bolt. Grateful for your intervention there, thought it probably was a 'no brainer' but as GRP is new to me thought I'd better ask!
Regards, Jim