Family 4, slow leak, suspect bathing platform bolts

Thoughts, Ideas and General Questions
andrew22
Posts: 5
Joined: Tue Mar 15, 2011 10:05 am

Family 4, slow leak, suspect bathing platform bolts

Post by andrew22 »

If I keep my family 4 in the water, I get a gradual build up of water in the bilge (rough calculations 1.5L/h, based on time in water and amount to be pumped out)
With boat out of water and bilge filled, no water drips out, so suspect pressure of water is forcing its way in somewhere.
Suspects are the 7 bolts under the waterline on the bathing platform.Little water enters the bathing platform itself.
I plan to remove, seal with Dow Corning and then re-assemble. (Other suggestions welcome)
The rear of 5 of the bolts is accessible. However the other 2 bolts appear to be hidden in the sealed section aft of the fuel and battery locker. (maybe add deck plate for access?) Does anyone know if these nuts are captive/glassed in?
Any thoughts or experience on how to solve issue much appreciated.

Thanks,
Andrew.
johnhalls
Posts: 28
Joined: Tue Mar 15, 2011 8:58 am
Location: AMIE - FAMILY FOUR - HULL NO 9879 - MARINER 60 - MILL RYTHE HAYLING ISLAND

Re: Family 4, slow leak, suspect bathing platform bolts

Post by johnhalls »

Hi Andrew.

I am no expert.
However............Is the water salty ?
I had a leak problem with my F4 but it turned out to be a rain leak. I found the leak where the cabin meets the floor the open area ( ie the door area)
Since the F4 is not originally built with a bathing platform I suspect your right however and I would remove it but be very carefull when you repair the damage. I wouldn't trust sealant but would plug the holes and use glass fibre with resin.

Good luck,
John