Hi.
I have a 536 Sunsport and I feel that it is under performing. The outboard is a 60hp mercury 'bigfoot' which works ok. I have been looking at the prop and I am not sure if its correct for the boat. I measured the diameter and it is 10.5 inches and it has the number 14 on it ( i think this much be the pitch) and it also has 4 blades on it rather than the normal 3.
I was wondering if anyone could give me an idea if this may be ok or is there room for improvement.
Many thanks
Peter
536 propeller
-
dellquay13
- Posts: 556
- Joined: Tue Mar 15, 2011 7:45 am
- Location: Pequod, F4 mk4, Milford Haven Marina
Re: 536 propeller
Hi,
You need to know your maximum engine rpm at wide open throttle (wot) to work out if you have the correct propellor. Check the Mercury/Mariner specs to find the recommended max engine rpm, compare it to your max rpm and alter the pitch by the required number of inchs. Increasing the pitch (yours is 14") cuts about 200rpm per inch and dropping the pitch adds about 200rpm for every inch.
If you search past threads for propellors and pitch you will find loads of information, but it all goes back to needing to know the max rpm you get from your engine...
One complicating factor is your 4 blade prop, you will lose top end speed but have better holeshots onto the plane. Try talking to a Mercury dealer for a recommended 3 blade prop for your engine and boat.
Hope this helps
Chris
You need to know your maximum engine rpm at wide open throttle (wot) to work out if you have the correct propellor. Check the Mercury/Mariner specs to find the recommended max engine rpm, compare it to your max rpm and alter the pitch by the required number of inchs. Increasing the pitch (yours is 14") cuts about 200rpm per inch and dropping the pitch adds about 200rpm for every inch.
If you search past threads for propellors and pitch you will find loads of information, but it all goes back to needing to know the max rpm you get from your engine...
One complicating factor is your 4 blade prop, you will lose top end speed but have better holeshots onto the plane. Try talking to a Mercury dealer for a recommended 3 blade prop for your engine and boat.
Hope this helps
Chris