mariner 25 EFI

Thoughts, Ideas and General Questions
stevew
Posts: 11
Joined: Sun Jun 05, 2011 5:05 pm

mariner 25 EFI

Post by stevew »

Hi all
I have a Mariner 25 EFI on my 4+2. The alarm is constantly going off for no reason normally when I slow down after a good burst of speed. Engineer been out 3 or 4 times but no cure yet. Any ideas at all would be most welcome. it is two years old and still under warranty.
SteveW
rbmatthews
Posts: 106
Joined: Tue Mar 15, 2011 9:02 am
Location: Northeast Scotland

Re: mariner 25 EFI

Post by rbmatthews »

Hi

I presume you mean the alarm on the remote control unit? I don't have direct experience of that particular engine, so others may be able to be more specific, but some generic ideas to consider are:

1. If it is still under warranty, then you should be able to get a Mariner agent to connect it to their diagnostic software, as the ECU should have logged what the problem was.

2. If you have a Mariner SmartCraft system installed, scroll through each of the readouts to see if anything is abnormal - battery voltage, water pressure, water temperature, oil pressure, oil temperature, etc.

3. Something partially blocking the water intake and reducing water pressure at low revs but not at high revs.

4. Too much water in the water-separating fuel filter (if it has one).

5. Could be a faulty sensor of something without anything being wrong - we had that once with a Mariner 75.

Hope this helps,

R.
Swannanoa, 1989 Shetland Family Four
http://shetlandf4.wordpress.com
daveinglasgow
Posts: 680
Joined: Tue Mar 15, 2011 9:04 am
Location: Dave Ashton, Shetland 610 Glasgow & Loch lomond

Re: mariner 25 EFI

Post by daveinglasgow »

Hi

alarms are there for a reason and this is to to tell you something is wrong or like cars the sensor is faulty! Not sure where you are but a mariner/ mercury dealer will sort this out for you.

Dave
http://www.ashtonmarineservices.co.uk, Brokergae, Trailers, advice, boat transportation 0759 563 8185
https://www.facebook.com/ashtonmarineservices