can anyone tell me? I have a Shetland 27 and notice that above the dashboard, where the dashboard meets just before the screen, that there are hinges. I am assuming that this means I can lift the dashboard consal up? I have not attempted it as yet, as I am worried that there may be many connections the other side of it.
Can anyone advise me please, and tell me if I can just lift it up, or do I need to disconnect anything, such as taking off the steering wheel. Thank you
shetland 27
-
Trv2t
- Posts: 3
- Joined: Mon Aug 12, 2013 6:52 am
Re: shetland 27
Yes, it lifts up.
Only had my boat a couple of months but have lifted the steering console.
It is reasonably heavy so helps to have a friend to help hold it whilst you look inside. All the cables reached ok apart from the search light cable that was a bit short and the connector pulled apart. (Think this is an aftermarket fitment on mine So perhaps the electrician was short on cable
)
You can see the back of the instruments and the back of the 240v mains panel and rcd.
I lifted mine as the rev counter was set wrong and only read 1200 rpm at full revs on the honda bf50. Now set correctly and reads fine. Can't believe the original owner used it for 4 years without wondering why rpm was so low!
Trevor.
Only had my boat a couple of months but have lifted the steering console.
It is reasonably heavy so helps to have a friend to help hold it whilst you look inside. All the cables reached ok apart from the search light cable that was a bit short and the connector pulled apart. (Think this is an aftermarket fitment on mine So perhaps the electrician was short on cable
You can see the back of the instruments and the back of the 240v mains panel and rcd.
I lifted mine as the rev counter was set wrong and only read 1200 rpm at full revs on the honda bf50. Now set correctly and reads fine. Can't believe the original owner used it for 4 years without wondering why rpm was so low!
Trevor.