does anyone have any advise or tips!! I have a Shetland 27i diesel, with a YANMAR 3JH4E (40hp engine). I have just completed a full service on her, 'so if anyone has the same engine and needs advise or help, let me know', but the only problem I have come across is the cooling system (ie: drain and replace coolant with correct antifreeze). The manual shows the drain cock being behind the alternator drive belt cover, below the hose that connects to the water pump. As there is little room within the hull to see the drain cock, I used a flashlight and mirror but still cant see or find it!! It was a tight squeeze just to remove the nuts from the drive belt cover, so it seems as if there is not a hope in hell of ever finding or getting to the coolant drain cock!! My next attempt was to use a marine vacuum pump, and pump out the coolant from the top filler cap. The very thin pump tube only goes in about an inch, therefore the only coolant that could be pumped out is the little from the top.
I am now thinking, 'as I have done so for the past week'
I would be most greatful if anyone has any knowledge of this that they could pass onto me, so as to complete a perfect full service on my craft.
'I have even tried to remove bottom hoses of the cooling system, but there is just no room within the engine bay to reach or get to any of the hose clamps' !!
I really would love to complete the whole full service myself, rather than take the craft into a marine workshop, because I have now completed 99.5% of the full service and it would be nice to pass my knowledge onto others.
My apologies for such a long post, but as I am sure you will all agree this is something that does need to be explained fully.
Thanks folks for taking the time to read this, and I really would appreciate any positive feedback. Thanks guys & girls
all the best, Mike