Holes in 4 +2 windscreen for wiper...How big?

Thoughts, Ideas and General Questions
aggalletley
Posts: 63
Joined: Fri Feb 24, 2012 4:44 pm

Holes in 4 +2 windscreen for wiper...How big?

Post by aggalletley »

Hi everyone...have found a manual windscreen wiper from Sheredan Marine on the Thames. The shaft which goes through the windscreen is 11mm or 7/16 inch diameter. I seem to remember two holes on my 4 + 2 screen with rubber bungs. As boat covered and laid up for winter can not get aboard to check these fitting holes. Anyone know the diameter of these holes in the screen ? Are there 2 or two for fixings of motor and one for wiper shaft ?
The wiper I have found needs the one hole of 11mm. Can anyone help out ? Many thanks
Andrew
User avatar
admin
Site Admin
Posts: 862
Joined: Sat Feb 19, 2011 3:00 pm
Location: "Phonix" , Tuckton Basin, Christchurch

Re: Holes in 4 +2 windscreen for wiper...How big?

Post by admin »

We will be on our 4+2 this weekend. I will have a look

Sue
There is NOTHING--absolutely nothing--half so much worth doing as simply messing about in boats.
Kenneth Grahame
ladydawn
Posts: 99
Joined: Tue Feb 26, 2013 4:26 pm
Location: 4+2 soft top with 75 hp Honda on twin axle extreme trailer .

Re: Holes in 4 +2 windscreen for wiper...How big?

Post by ladydawn »

Sorry i cant help as we have a soft top 4+2 with lay flat windscreen hence no wipers and apparently no way of
fitting them !!! :roll:
User avatar
admin
Site Admin
Posts: 862
Joined: Sat Feb 19, 2011 3:00 pm
Location: "Phonix" , Tuckton Basin, Christchurch

Re: Holes in 4 +2 windscreen for wiper...How big?

Post by admin »

THe holes on our boat are 10mm. The drivers side has two holes. One for the wiper and one for the washers. On the other side there is just one hole.
You do not have the required permissions to view the files attached to this post.
There is NOTHING--absolutely nothing--half so much worth doing as simply messing about in boats.
Kenneth Grahame
aggalletley
Posts: 63
Joined: Fri Feb 24, 2012 4:44 pm

Re: Holes in 4 +2 windscreen for wiper...How big?

Post by aggalletley »

Thanks Sue...you make me wonder...you say 10 mm holes the wiper I have found says 11mm just wonder if they are really the same because otherwise they would never sell any wipers. I'll give the supplier a ring at the next week. Bottom line is I can wait till later in the year and spend a couple of days cruising up to the boatyard and physically see if the wiper will fit....one of our favourite moorings is about half an hour further up river from the boatyard.
Thanks for remembering really kind of you
Andrew
User avatar
admin
Site Admin
Posts: 862
Joined: Sat Feb 19, 2011 3:00 pm
Location: "Phonix" , Tuckton Basin, Christchurch

Re: Holes in 4 +2 windscreen for wiper...How big?

Post by admin »

It was a tatty old IKEA tape measure!!!!!
Lol
There is NOTHING--absolutely nothing--half so much worth doing as simply messing about in boats.
Kenneth Grahame