Hello and Splashwell question

Thoughts, Ideas and General Questions
ChrisnRosie
Posts: 9
Joined: Fri Oct 10, 2014 1:46 pm
Location: North Coast, N.Ireland

Hello and Splashwell question

Post by ChrisnRosie »

Hi all,

New on here and quite new to boating. We bought a 536 a couple of weeks ago so no doubt this forum will be very useful :D

I've had a look through the forum and perhaps haven't looked well enough, however I have a question (probably the first of many) and wondered if someone could help.

Our 536 is No:6620, which I think is 1980, though I haven't found the HIN yet to confirm. The splashwell runs straight across the stern parallel to the transom. I notice on some 535's / 536's that the splash well curves in on the outer edges, hugging the engine and allowing more room for seating. So my question...

1) Was the curved or in fact any splashwell aftermarket or factory fitted?

Ours has some cracking on it and needs repaired so we wondered if it's worth changing it at the same time to a curved version. Also appreciate that the canopy will need an additional section added to it if we did that...

Many Thanks,

Chris & Rosie
User avatar
bobtooke
Posts: 110
Joined: Sun Aug 11, 2013 11:26 pm
Location: South London / Newhaven

Re: Hello and Splashwell question

Post by bobtooke »

Hi Chris & Rosie,

Welcome to this forum and congrats on your new acquisition! The Shetlands are tough little boats and a great deal of fun for new boaters. I got my 535 last year and am really enjoying ownership of her.

I believe the sculpted splashwell you refer to was fitted to the later 536's (and Family Four) and was indeed a factory fit. I suppose that you could make something similar up yourself but it does seem a lot of work to do so. Not to mention the worries of structural integrity and insurance complications. Better to enjoy her how she is I think.

How bad is the cracking? Usually its just minor gelcoat cracks which are relatively easy to repair. No need for extensive GRP work if its structurally intact Theres lots of instructional stuff on YouTube to cover how best to do it. You can get gelcoat filler from most chandlers which should do the job fine.

By the way, have a good look around the transom for the HIN - often it is imprinted into the GRP gelcoat somewhere.

Hope this helps,

Bob
"Don't worry, I'm completely lost too"
Currently aboard "Sweet Kismet", Shetland 535 / Honda 50

Experts in freshwater treatment to the marine industry.
http://www.amphibia.co.uk
ChrisnRosie
Posts: 9
Joined: Fri Oct 10, 2014 1:46 pm
Location: North Coast, N.Ireland

Re: Hello and Splashwell question

Post by ChrisnRosie »

Hi Bob,

Thanks for the reply and info, much appreciated.

I'll have a hunt around for the HIN. We've just dropped her up to get the engine given a once over by a pro, so fingers crossed :D after that we'll look at the fibreglass though it appears to be superficial. I think cracking has appeared along the base of the splashwell where it attaches to the transom due to people standing on it :o it's been repaired before so hopefully no issues. Thanks for the info re gelcoat filler, handy to know. We'll probably sand her back and paint again over the winter.

All the best,

Chris
Tasssos8
Posts: 5
Joined: Sun Dec 07, 2014 1:19 am

Re: Hello and Splashwell question

Post by Tasssos8 »

[quote="ChrisnRosie"]

Our 536 is No:6620, which I think is 1980, though I haven't found the HIN yet to confirm. The splashwell runs straight across the stern parallel to the transom. I notice on some 535's / 536's that the splash well curves in on the outer edges, hugging the engine and allowing more room for seating. So my question...


Regarding your date of make question, here is the list of the serials and years of make of all 536's.

Shetland 536 Numbers
Serial # Year
600 – 6209 1973
6210 – 6761 1974
6763 – 7067 1975
7068 – 7644 1976
7645 – 8419 1977
8420 – 8443 1977
8444 – 8555 1978

I am a paid member of the shetland boats website and I have access to all serials of all Shetland boats ever made.

I too have a 536 but it is the one with the cut out wel which I find practical... but there are many differences throughout all 536's and 535's. The hull, the most important, is the one which remained unchanged till today!!! And that is the most important :)
Enjoy your boat mate!