Engine water flush tank

Thoughts, Ideas and General Questions
Post Reply
solex
Posts: 49
Joined: Mon Mar 21, 2011 10:46 am
Location: Shetland 570 CRAGEN, Wrexham, Mercury 75hp 2st, Seagull Silver Century

Engine water flush tank

Post by solex »

Any ideas where to find a water bin/tank, 70cm x 70cm x 70cm minimum, so I can run my Mercury 75 in?
trickytrev
Posts: 43
Joined: Sun May 22, 2011 12:39 pm
Location: Quicksilver Pilothouse with 60 Mariner 4stroke. On a Trailer.

Re: Engine water flush tank

Post by trickytrev »

Hi solex, Your engine is a bit big for a bucket lol. So if you have a tap close by then invest in a pair of I think there called Muffs.
You connect a hose pipe to what looks like a pair of head phones and the water runs out of one end.. you put these onto your engine with the water connecting to the water intake on your engine.. Start up your engine and the water will flow through your engine.. Only with yours It might not pass straight through because your engine may have a thermostat..Once the engine has reached normal running temperature then the thermostat should open and then you will see water shooting up into the air. Only use these in neutral never open the power. Cheers T
hoblands
Posts: 26
Joined: Tue Mar 15, 2011 7:44 am
Location: Wilson Flyer 17 (Previously several Shetlands)

Re: Engine water flush tank

Post by hoblands »

Do you use wheelie bins for rubbish collections in your area?

We have a spare one acquired from the council, half filled with water (and a bit of washing up liquid to lubricate the engine). Motor clamped to the side, makes a perfect flush tank.

Paul
solex
Posts: 49
Joined: Mon Mar 21, 2011 10:46 am
Location: Shetland 570 CRAGEN, Wrexham, Mercury 75hp 2st, Seagull Silver Century

Re: Engine water flush tank

Post by solex »

OK. I really want to use a tank to cut down on the very loud exhaust noise when using the Flush Muffs.
Wheelie Bin too narrow and tall.
Ta.
zimboy
Posts: 15
Joined: Tue Mar 15, 2011 7:49 am
Location: Barnacle Bottom, Shetland 535, Gloucestershire

Re: Engine water flush tank

Post by zimboy »

I have used a 44 gallon drum cut in half before works well ( the steel type that oil comes in).
Hope this helps

John
paul
Posts: 6
Joined: Fri Feb 25, 2011 9:18 pm

Re: Engine water flush tank

Post by paul »

I use a plastic domestic cold water tank bought from DIY stores.

Cheap, various sizes, and the motor can even be tilted in an out of the water. :)
solex
Posts: 49
Joined: Mon Mar 21, 2011 10:46 am
Location: Shetland 570 CRAGEN, Wrexham, Mercury 75hp 2st, Seagull Silver Century

Re: Engine water flush tank

Post by solex »

Tried Wickes, B&Q Country Farms etc and all they got are Water Butts. Too small.
Where to try next?
paul
Posts: 6
Joined: Fri Feb 25, 2011 9:18 pm

Re: Engine water flush tank

Post by paul »

This is the sort of thing I use. Plenty big enough for any engine...

http://www.tradingdepot.co.uk/DEF/produ ... %20Cistern
Neily
Posts: 84
Joined: Thu Mar 17, 2011 11:03 pm
Location: Shetland Black Hawk No.520 - on Loch Awe - Mercury 75

Re: Engine water flush tank

Post by Neily »

poundstrecher do a huge 160l clear plastic storage box for only £14.99 just perfect for your needs, find your local store here http://www.poundstretcher.co.uk/store-locator.html or try http://mydeco.com/p/wham-crystal-160l-s ... EV7F27TFP/

they work a treat & allow me yo fire up my 75hp every month or so :)
solex
Posts: 49
Joined: Mon Mar 21, 2011 10:46 am
Location: Shetland 570 CRAGEN, Wrexham, Mercury 75hp 2st, Seagull Silver Century

Re: Engine water flush tank

Post by solex »

Many thanks.
Went to Oswestry Poundstretcher and bought a 150Lt storage bin. Was able to run engine in it ok. The engine starts and ticks over nicely with no nasty noises. Even ran in gear slowly. But when raising the engine up, the bottom fin caught and cracked the bin. At least the engine seems to start and tick over ok.
Post Reply