Keel repair needed...metal plate ?

Thoughts, Ideas and General Questions
Wolly
Posts: 9
Joined: Wed Sep 12, 2012 11:26 am

Keel repair needed...metal plate ?

Post by Wolly »

Hi all, i have come by this metal plate, or keel band if you can call it that

Image

This is a Sealark boat, i am not sure if they had these originaly fitted, i cant see it myself unless somebody can say. It is a galvanised metal plate riveted inplace then has been either gelcoated over or epoxy filled over. As you can see if has cracked off near all the keel length.

I am unsure as to wether remove it and redo the keel or to grind back and add a few layers of woven matt then topcoat.

But is it a standadrd thing on these boats?


cheers


wolly :D
Wolly
Posts: 9
Joined: Wed Sep 12, 2012 11:26 am

Re: Keel repair needed...metal plate ?

Post by Wolly »

Can nobody help with this then ? Lots of lookers but no replys.
User avatar
Coddy
Posts: 96
Joined: Thu Sep 01, 2011 3:51 pm
Location: Dorset

Re: Keel repair needed...metal plate ?

Post by Coddy »

Hi Wooly

I would suggest that this has been done by a previous owner, I hope there are no hidden nasty supprises underneath it.
Personaly I would remove the plate, grind back to good GRP and make good the repair with new fibreglass matting working on the inside of the hull, then add a layer of gelcoat to the top, or on the outside so that it is level with the old gelcoat.

All keelbands I have seen are normally about 1.5" wide and are normally used when beach launching and recovery is required.

Good luck

Dave