610

[ANTHONY]

hi everyone, we have bought a shetland 610 last summer, we are looking for any help as regards of finding information on it
we are loking for seat , cushions seat, canope and frame and what is the best solution for damp issue...... wiring panel etc..
regards
anthony

[KenHurst]

Hi Anthony, and welcome. I recently joined the forum too and have found the best way of getting answers is to establish seperate threads for each specific question.
Good luck.
Ken

[daveinglasgow]

Hi

Solar for the vents x 2 i.e. push and pull air

i split my wiring to nav and internal and these are on separate batteries with the internal panel being inside and the outside one being above the steering wheel but cost more due to being waterproof. I then add a spare battery to weigh the front down but fully charged and quick release connectors ( maplins £10-15.00) so I could use if I had a problem.

Oh I also use the following

auto bilge
fish finder
VHF
Nav lights
GPS
12v socket

Internal so far is
sink ( water pump)
lights
radio ( not connected yet)
12V socket

and it will have tv

Dave

[daveinglasgow]

Hi

Solar for the vents x 2 i.e. push and pull air

i split my wiring to nav and internal and these are on separate batteries with the internal panel being inside and the outside one being above the steering wheel but cost more due to being waterproof. I then add a spare battery to weigh the front down but fully charged and quick release connectors ( maplins £10-15.00) so I could use if I had a problem.

Oh I also use the following

auto bilge
fish finder
VHF
Nav lights
GPS
12v socket

Internal so far is
sink ( water pump)
lights
radio ( not connected yet)
12V socket

and it will have tv

Dave

[ANTHONY]

Hi ,
thank you for your reply
anyone would have the mesurement of the inside seating v shape cushions or know where to get them
thank you
anthony

[daveinglasgow]

far far cheaper to make so efoam for the foam and then get a full role of leatherette or meterial as it works out less than using the 12-15 meters you will use and you will have spare for next time.

dave

[ANTHONY]

hi everyone, which weight anchor is needed on a 610 as just notice the boat hasnt got one...
many thanks
anthony

[daveinglasgow]

Hi

there are two types of anchor and hence you need to state what sort of sea bed you plan to operate in. sorry but without this we can not help or give you a clear answer

Dave

[ANTHONY]

thanks Dave, just to go into hamble river seawater will ask later on what is the sea bed is
thanks again

[admin]

If its the Hamble then its mud. we moor in the Hamble

Sue - ADMIN