Rendering on 610

Thoughts, Ideas and General Questions
Theladsharp
Posts: 4
Joined: Mon Jul 23, 2012 5:41 pm

Rendering on 610

Post by Theladsharp »

Hi
Can anyone tell me which profile of fendering I should order for my 610. Is it a pig of a job to fit? Would I be better restoring the existing rubber and, if so, what's the best stuff to clean it with?

Any advice gratefully received. :D
User avatar
admin
Site Admin
Posts: 862
Joined: Sat Feb 19, 2011 3:00 pm
Location: "Phonix" , Tuckton Basin, Christchurch

Re: Rendering on 610

Post by admin »

You need to look at the profile of the rubber, my guess its a D profile. Have a look at the Wilks website.

They do a variety of fendering. It's can be a bitch of a job. You need to get the rubber warm and it takes a minimum of 2 people. We replaced ours on our 570. we softened ours in a bath of warm water and then ran downstairs to the boat. Our neighbours are very understanding. Stretch it and get your partner to fit in place.

ADMIN
There is NOTHING--absolutely nothing--half so much worth doing as simply messing about in boats.
Kenneth Grahame
Theladsharp
Posts: 4
Joined: Mon Jul 23, 2012 5:41 pm

Re: Rendering on 610

Post by Theladsharp »

Thanks so much for taking the time to post a reply. I think I'll leave the existing fendering in place if its that much of a nightmare to replace. There is a strip of approx 5 feet missing along the stern. If anyone has this sort of length lying around i would happily pay for it