Several months ago I purchased a second hand Shetland Family 4 Mk 1 which I intend doing up this summer. I was also thinking about getting an outboard but I want to get some idea what size of engine could be used with this boat and would not cost an arm and a leg. Hopefully, it will be used on Ireland’s waterway, rivers and in inshore. The boat will be carrying 3 persons and I’m not really into speed . Any kind of recommendations on this matter would be welcomed.
I think that if you are going to use it on the sea, even inshore, you need something like a 75 hp, to deal with tidal currents and the like. For the rivers and waterways, others will be able to advise better, but something much less should do the trick.
The F4 should take up to 70-90 hp, depending on the model. Check the Shetland website.
If speed is not your thing and for many people where they go also dictates this i.e. the inland waters that you have said in your post due to speed limits I would go for a good 4 stroke and around 15hp and no more than 20hp. Please not you would get away with a 10hp but you are better to have a bit more power and not rev the nuts off it as this is better for the engine and for fuel etc.
Oh this boat will need around 50hp to get it up so there is no point in buying anything bigger unless you want to be going 20mph upwards.
What's the cruising speed with a 15 hp?
I'm hoping to buy something like a family 4 for use in Essex and Suffolk estuaries and perhaps venture in to the broads.
I've seen a lot advertised with 15's and then a big gap until 60 hp upwards.
I don't really want a big engine and I'm happy to pootle around at 8-10 knots.
I realise that my reply comes more than a year later but I thought it could be handy to future searchers of the forum.
I have a Shetland 536 F4-II with an Honda BF15 15hp. Boat weighs about 600kg, 50 for batteries, 50kg engine, 50kg benzine and equipmentIt, 130kg my wife and me, a total of 880-900kg. It gets up to 9-10 mph but I am always in fresh waters, small rivers and canal or small lakes. I live in Amsterdam, Holland and I only visit occasionally big sea canals where it is a bit shaky although the engine is enough to get me around for short distances like cross the canal or go for a mile maybe.
In the rivers, canals and lakes though I have as much power as I need due to the low speed limit here. I cruise usually at around 4-5 mph and I do 3-4miles per litre. Really economical.
Note that some engines like that Honda of mine (long shaft) has shaft length of 57cm but my transom is 51. For better performance, push and speed I have to lift the engine about 5-6cm (two inches+) I lost half a season with dragging too much water and not achieving much.
I will post again the better (hopefully) performances.
Good luck with all.
Last edited by Tasssos8 on Mon Jul 20, 2015 10:29 am, edited 1 time in total.
I just put the engine 5cm higher today and took it out for a test. I got the same maximum speed more or less but I got very easily and quietly to 6-7knots and I cruised much lighter with less waters at the back.
For big engines and fast speed boats every detail like that can make a huge difference though.