New Owner Shetland 535

Thoughts, Ideas and General Questions
stuart50
Posts: 48
Joined: Wed Jun 18, 2014 8:20 pm

New Owner Shetland 535

Post by stuart50 »

Just registered as a new owner of a Shetland 535. Having skimmed through the various forums on Shetland 535 it would appear a common problem with most 535 that canopy's are hard to come by second hand/used. I to would be willing to seek purchasing a used top as money is tight . Otherwise the boat is a little cracker.
1 slight problem would be the outboard motor, Mariner 30HP 2 stroke seems to vibrate when accelerating. Also seems lumpy at low revs. Plugs appear fine.
Any suggestions would be very welcome.
daveinglasgow
Posts: 680
Joined: Tue Mar 15, 2011 9:04 am
Location: Dave Ashton, Shetland 610 Glasgow & Loch lomond

Re: New Owner Shetland 535

Post by daveinglasgow »

Hi

clean the carbs and increasing the tick over speed by adjusting the nut just past where the throttle cable connects to the engine. this can also sometimes be a black plastic circle but either way you will find it. even better get it serviced

dave
http://www.ashtonmarineservices.co.uk, Brokergae, Trailers, advice, boat transportation 0759 563 8185
https://www.facebook.com/ashtonmarineservices
NelsonAdmiral
Posts: 24
Joined: Thu Oct 10, 2013 6:08 pm

Re: New Owner Shetland 535

Post by NelsonAdmiral »

Check the compression on each cylinder. Borrow or buy a compression kit. Just screw it into the spark plug hole one by one and crank. read scale. may indicate poor compression on one cylinder which in turn will suggest overhaul piston rings or something.
daveinglasgow
Posts: 680
Joined: Tue Mar 15, 2011 9:04 am
Location: Dave Ashton, Shetland 610 Glasgow & Loch lomond

Re: New Owner Shetland 535

Post by daveinglasgow »

Hi

sorry to disagree but compression will give you poor performance and would not make it vibrate or be lumpy. Compression tests are also v cheap[ i.e. start at a tenner) and should be used before you have the engine as in most cases if compression is low it will not be worth repairing unless its less than 10 years old and even then some will be borderline. What you have is a fuel issue.

Dave
http://www.ashtonmarineservices.co.uk, Brokergae, Trailers, advice, boat transportation 0759 563 8185
https://www.facebook.com/ashtonmarineservices
stuart50
Posts: 48
Joined: Wed Jun 18, 2014 8:20 pm

Re: New Owner Shetland 535

Post by stuart50 »

Many thanks for your answers. I removed the motor from the boat.. After I replaced it, it appears to have solved whatever caused the vibration. Possibly the bolts holding on the outboard wasn't tight enough . I have also put some additive into the fuel tank which hopefully cleaned out any residue in the engine. Fingers crossed for some happy lump free cruising :D
stuart50
Posts: 48
Joined: Wed Jun 18, 2014 8:20 pm

Re: New Owner Shetland 535

Post by stuart50 »

IMG_0087 (1).JPG