Here is the start of my dirty work. sanded some paint off the floor yesterday .
The stringers are short and seem to be in good order could i put in new stringers in on top of the old ones or
put new stringers in beside the old stringers, i took some photos on my phone there not great. Will be back out to work on her Monday and finish stripping the paint from the floor.
Any advice would be great.
Cheers.
I've just started rebuilding my 570 which has been stripped back to the bare shell
My new floor has been cut and glassed underneath, ready to be fitted tomorrow,
I've left about 4 inches of unwetted fibreglass around the external edges so when I put down the deck down the correct way up these can be wetted onto the hull sides
I've left about a 1cm gap all around the deck so that it doesn't touch the sides and create stress points
My stringers are exactly the same, so I've measured with a straight edge across the width and cut some external ply the required size to span across
this will be then covered with a sheet of fibreglass and the deck put down on top of the wet stringers
After running additional strips around the perimeter and against the side I can put down a couple of sheets of matting on the top of the deck
This is my first boat and first attempt at fibre glassing. After seeking lots of advice it turns out it quite straight forward
Hello and thank you for the reply Simon.
im trying to visualize your method if you have any photos that be great.
The 1cm gap all round the deck will i do the same with the stringers.
cheers
Once I have then cleaned up the floor and surrounding areas I will cut a piece of glass that will sit on top of these and fold down each side onto the stringer. I wont resin it in until I am ready to put the deck down so that it will go on top wet stringers.
heres a picture of a piece of prepared deck, glassed underneath and with un wetted glass ready to fold up and glass onto the inside of the hull.
Yes now i follow you. I wanted my stringers to go the full way across and rise my deck a little . Would that be a no no ?
Have not got much done been dodging the rain few hours here and there. Found a 3 soft spots along one side
Will grind them out and glass them in after finished sanding the inside of the hull. only a few hours left of that thank god im wearing a suit full face mask and the dust is flying . The timber glass and resin came today so nearly all set
Cheers for the reply
The soft spots got a lot bigger but thank god i can fix it . This is someone else (not) so handy work. he must have chopped up some 2/4 into inch bits poured resin over them and glassed them it.The whole lot and stringers are water logged rotten and coming out. The other side is not soft but i think il have to remove it to. just have to think of what to replace it with foam or wood ?
Stringers out today in the rain too ha.Im using a grinding disk to grind down the old glass and paint off. and its working well.Will switch to a sander for the sides.Cant wait to finish this stage
Hi antoncarroll I have recently bought a 535 suntrip as a first boat project. Thanks to your pictures I also have the same second layer on both sides of mine. I presumed it was for added strength also to add level to the deck boarding. Alas your first picture of the small hole looks like mine. I was thinking of re glassing over but not sure if this is the right thing to do as I say I am a complete newbie. Any help or advise would be much appreciated.
have a look at what I did on Meggy (535 refurb step by step). I wanted to ensure good ventilation and good drainage to the bilge and designed my solution with that in mind.
I'm happy with it up to now. We'll have to wait and see how well it works in use.