I'm struggling to get any info on how to drop the leg on on these common outboards to get to the impellor. I have got all the visible bolts out but the leg only drops about 10-13mm. Any idea where I might find a free manual or advice to help me?
Chris
I have now sold my 1989 F4 mk4, 2015 70hp 4str Yamaha. Milford Haven. I proudly owned it for over 20 years, before changing to sailpower and a yacht...
Does this motor have a separate gear linkage or is it just a rising drive shaft to switch between F and N, as it has no R? I can't see where the gear lever could be connected to a separate lift rod, as it is directly in line with the drive shaft. The leg is circular section and seems very small to have a drive and link rod inside.
Does anyone know if I need to disconnect anything at the top of the leg as well as at the bottom?
Cheers,
Chris
I have now sold my 1989 F4 mk4, 2015 70hp 4str Yamaha. Milford Haven. I proudly owned it for over 20 years, before changing to sailpower and a yacht...
... Lower cowling off, transom mounting assembly off, POWERHEAD OFF!!! Just to get to the impeller in the lower leg? Yep, that's another gasket I need to source, along with a new pickup pipe and bottom bayonet grommet which sheared off along the way.
That'll teach me a lesson about leaving some jobs to an expert.
I have now sold my 1989 F4 mk4, 2015 70hp 4str Yamaha. Milford Haven. I proudly owned it for over 20 years, before changing to sailpower and a yacht...
At least it will all fit in the wheelie bin now it is all in bits...
I have now sold my 1989 F4 mk4, 2015 70hp 4str Yamaha. Milford Haven. I proudly owned it for over 20 years, before changing to sailpower and a yacht...