Newbie question - 27 air draft

Thoughts, Ideas and General Questions
smug1uk
Posts: 2
Joined: Sun Sep 09, 2018 7:31 am

Newbie question - 27 air draft

Post by smug1uk »

Hi everyone

I'm looking to purchase my first Broads cruiser and have been considering the 27, would like to know if this boat will go under Potter Heigham bridge? I'm guessing it will probably go under at low tide but am unable to get a definite answer.


Any help would be greatly appreciated.
DACS
Posts: 77
Joined: Sat Jul 19, 2014 9:59 am

Re: Newbie question - 27 air draft

Post by DACS »

I have a Shetland 27i, the inboard version. My measurements are as follows:
Canopy & Mast up - 7' 11"
Canopy and Mast down - 7' 7"
Screens down - 6' 9"

Various web sites list Potter Heigham Old Bridge as 6' 6" or 6' 8" at average water, whatever that means. The highest part on my boat when the screens are down is the engine control lever, so you would have to align this with the centre of the arch

The only good news is that, if you did hit the bridge, it would automatically knock it into reverse and back out again!

Different versions of the boat may differ slightly so you would need to measure the individual boat. Also, some versions have the controls lower down which would make it a little easier. However, I think that all versions would either be a very tight fit or too high.
smug1uk
Posts: 2
Joined: Sun Sep 09, 2018 7:31 am

Re: Newbie question - 27 air draft

Post by smug1uk »

Thanks for that information, I had thought the engine control would be the highest point and have seen a couple of 27's with a much shorter lever fitted, now I know why. Does the screens down measurement include the engine control lever?
DACS
Posts: 77
Joined: Sat Jul 19, 2014 9:59 am

Re: Newbie question - 27 air draft

Post by DACS »

Yes, my measurements apply to my boat and, with the screens down, the highest point is the control lever so that it the measurement that I need. The next highest point is the top of the instrument panel moulding and this is only a few inches lower (see photo).

I have seen one Shetland 27 advertised that has have the engine control lever mounted lower, on the side panel next to the helm seat. This has an outboard engine but but presumably it would be possible to arrange a similar set up for an inboard.
You do not have the required permissions to view the files attached to this post.