Shetland 4/2 Leak

Thoughts, Ideas and General Questions
ShoresideJim
Posts: 1
Joined: Sun Apr 07, 2019 7:08 pm

Shetland 4/2 Leak

Post by ShoresideJim »

Hi all, I have a Sheltland 4 plus2 that has water coming in somewhere, in the cabin as you step down onto the floor we have a carpet and on top of the carpet we had a mat, when the mat was lifted we noticed that the carpet was soggy, but only an area of about a foot square. Having dried it out we saw on a later visit that it was wet again and on lifting the carpet saw a white bung/cap, the water is coming from this but not loads.
What I want to know is, does this boat have a built in bilge pump as standard and if so does this pump out any water when the engine is running, if not, where would this water be coming from. The fore and aft sections are dry. Thank you in advance.
DACS
Posts: 77
Joined: Sat Jul 19, 2014 9:59 am

Re: Shetland 4/2 Leak

Post by DACS »

It is unlikely that you boat has a built-in bilge pump. Even it it does, it is unlikely to pump out automatically when the engine is running. Automatic bilge pumps normally work regardless of whether the engine is running so that they can operate when the boat is unattended but rely on a good battery.

Assuming you cannot find a bilge pump on board, you need to pump out the water using the hole that you have found under the carpet. A hand operated bilge pump will do, although it may be quite hard work.

The most likely way for water to get in is from the cockpit. Canopies can often leak and even if the cockpit is supposed to be self-draining, water can still find its way in through the lockers.

Pump the water out and then see how soon it returns. You may find that it is sufficient to pump it ot each time you visit the boat and it is only reaching the carpet because you have allowed it to accumulate for a long time. Fibreglass boats are generally pretty watertight so it is unlikely to be a serious problem.
aggalletley
Posts: 63
Joined: Fri Feb 24, 2012 4:44 pm

Re: Shetland 4/2 Leak

Post by aggalletley »

Hi When I bought my 4 + 2 some 7 years ago a faulty water system meant when filling the water tank it overflowed into the boat and nearly sank it !
The void below the rear cockpit was at least a foot deep in water. This managed to get into the area under the cabin which is filled with buoyancy foam. For some reason there was a small hole 1/4 of an inch drilled in the wall between the rear void and the area below the cabin...water kept leaking into the rear void from that hole...it was yellow stained by the foam. I drilled a further hole near the bottom of the void space wall into the void below the cabin. (NOT THROUGH THE BOTTOM OF THE BOAT ! ) water continued to drain from this lower hole into the rear void for several months. I fitted a small bilge pump into the rear void. The water has not been seen since.
I have also noted that some 4 + 2s have a drain plug fitted to the lower of the stern for drainage purposes.

Guess you could also simply remove the inspection cover, perhaps remove some of the yellow foam fist size hole down to the bottom of the boat and then pump out excess water from there. It will take a long tome as I guess your foam is saturated.
Essential question is where is the water coming from ?
Water surrounding our boats is a joy....water in the boat is a bit more worrying. A couple of years ago I spent a year trying to find the source of water ingress under my sink in the cupboard there. Eventually saw a hairline crack in the water pump which over time filled the cupboard it was a tiny seep but over time always filled the area and drove me crazy.
Hope you manage to sort your problem out and that some of what I said above makes sense. Come back to me if confused
Andrew