Could anyone share ideas for stern mooring fenders to the bathing platform?
It seems quite unprotected particular where ladder drops down but maybe a bit low for a horizontal permanent fender?
We've just upgraded from a family4 to a 27i (2008), any other tips would also be greatly appreciated
Shetland 27i stern fenders?
-
DACS
- Posts: 77
- Joined: Sat Jul 19, 2014 9:59 am
Re: Shetland 27i stern fenders?
We always use springs to prevent the bathing platform from touching the pontoon when mooring stern-to. By springs, I mean a mooring warp (rope), stretched from the stern of the boat to the finger pontoon such that the tension prevents the boat from moving too far back.
if you really need fenders then you could probably hang them from the cockpit rails to lie vertically over the edge of the bathing platform but I have never need to do this. You could also hang them on the pontoon.
if you really need fenders then you could probably hang them from the cockpit rails to lie vertically over the edge of the bathing platform but I have never need to do this. You could also hang them on the pontoon.
-
leedsey
- Posts: 4
- Joined: Tue Jul 23, 2019 12:22 pm
Re: Shetland 27i stern fenders?
Thxs
Used springs before, although didn't know the term
Unfortunately no finger pontoon
I'll look into temporarily vertical fenders hung from cockpit rails
Used springs before, although didn't know the term
Unfortunately no finger pontoon
I'll look into temporarily vertical fenders hung from cockpit rails