Shetland 498 Windscreen (fitted to the top of the cabin)

Missing a vital part? Need to track down a spare? Just ask.
Lezz
Posts: 4
Joined: Wed Jun 26, 2019 10:32 pm

Shetland 498 Windscreen (fitted to the top of the cabin)

Post by Lezz »

Looking for a replacement windscreen (the one fitted to the top of the cabin) on a Shetland 498 if anyone has one for sale or could advise where I could purchase one, alternatively a pattern that I could use to cut one myself - many thanks
Lezz
Posts: 4
Joined: Wed Jun 26, 2019 10:32 pm

Re: Shetland 498 Windscreen (fitted to the top of the cabin)

Post by Lezz »

I have now been able to obtain a pattern template (for the top windscreen) and will in the next few days be able to cut a new screen from polycarbonate sheet for my boat - I can see that there are existing holes (5 off) around the perimeter of the upstand on the top of the cabin - that I presume are the originals that are used to attach the windscreen to - can anyone advise what type of fittings should be obtained to attach the screen to the boat - not sure if well nuts or rivit nuts or something else should be used?
vreagh
Posts: 327
Joined: Sat Aug 02, 2014 5:46 pm
Location: Cornwall

Re: Shetland 498 Windscreen (fitted to the top of the cabin)

Post by vreagh »

On my 535 I used stainless m6 screw with stainless mudflap washer under the head then a 2mm rubber washer either side of screen, another mudflap inside with a stainless nyloc nut (not overtightened) on inside. The rubber washers I cur from leftover floor matting.
535Mustard
Posts: 177
Joined: Sun Dec 29, 2019 11:07 am

Re: Shetland 498 Windscreen (fitted to the top of the cabin)

Post by 535Mustard »

Yes mine had stainless bolts with rubber washers between the screen and the cabin too
Lezz
Posts: 4
Joined: Wed Jun 26, 2019 10:32 pm

Re: Shetland 498 Windscreen (fitted to the top of the cabin)

Post by Lezz »

Thanks for the info - rubber washers and SS bolts at 6mm it is then
petjako
Posts: 1
Joined: Sat Sep 12, 2020 6:56 pm

Re: Shetland 498 Windscreen (fitted to the top of the cabin)

Post by petjako »

I'm lookink for this part for my 498 also, Is there any chanche to get the template scaned ?
Lezz
Posts: 4
Joined: Wed Jun 26, 2019 10:32 pm

Re: Shetland 498 Windscreen (fitted to the top of the cabin)

Post by Lezz »

Hi Petter - the template is too large to scan - it is one I made myself - after cutting out the polycarbonate (from my template) I needed to very slightly trim (the polycarbonate) to give a good fit. Not sure where you are based but you are more than welcome to use my template if you wish to pick it up .
Tdunbar0
Posts: 8
Joined: Thu Feb 20, 2020 2:38 pm

Re: Shetland 498 Windscreen (fitted to the top of the cabin)

Post by Tdunbar0 »

How did it turn out Lezz? Looking for one myself.