cabin/stern floor
-
Hermitage
- Posts: 2
- Joined: Sat Feb 29, 2020 6:57 pm
cabin/stern floor
I have recently purchased a Shetland cabin boat 570 and in the process of restoration the problem I have is the fibre glass floor ; has been punctured and the foam below is saturated and I am in the drying it I have cut 2 holes in the floor to dry and establish where the main bearers are as I would like to cut larger holes in the floors and make bilge holes to dry it out can anyone tell me where the the main bearers are or give some advice how to do this
-
DeanfromLeeds
- Posts: 21
- Joined: Sat Mar 26, 2011 11:40 am
Re: cabin/stern floor
Hermitage,
I will be surprised if it dries out this way, I have had a Shetland 570 and two 536's with this problem and I have had to cut the floors out completely and take the foam out and then re-deck the boats. I left one for over 12 months in dry storage and it was still soaked when the deck was taken out. You may have noticed that I am not the best at fibreglassing but it works for me.
Some people may have had a better way to do this.
By the way I converted the 570 in to a centre console fishing boat, it now has an 80hp four stroke Yamaha on the back and is an awesome boat, even though I say so myself.
Regards Dean
I will be surprised if it dries out this way, I have had a Shetland 570 and two 536's with this problem and I have had to cut the floors out completely and take the foam out and then re-deck the boats. I left one for over 12 months in dry storage and it was still soaked when the deck was taken out. You may have noticed that I am not the best at fibreglassing but it works for me.
Some people may have had a better way to do this.
By the way I converted the 570 in to a centre console fishing boat, it now has an 80hp four stroke Yamaha on the back and is an awesome boat, even though I say so myself.
Regards Dean
You do not have the required permissions to view the files attached to this post.
-
OnceaFLM
- Posts: 7
- Joined: Tue Jul 10, 2018 9:56 pm
Re: cabin/stern floor
Have to agree about it never drying out, mines been "drying" for nearly 2 years and is still wet. It must be something to do with the "open cell foam". The wood in the cockpit area has completely rotted away, the table socket corroded and the fibre glass collapsed. Its going to be a big job for me with a massive leaning curve I think. Good luck with yours.
-
535Mustard
- Posts: 177
- Joined: Sun Dec 29, 2019 11:07 am
Re: cabin/stern floor
I guy next to me on my mooring has a MK2 570.
He now uses 160L of fuel to do a trip that used to use 30L.
The foam in that is soaked, it must be really heavy, hence the fuel use.
It's sat on the mooring for almost a year now as he can't afford to use it.....
He now uses 160L of fuel to do a trip that used to use 30L.
The foam in that is soaked, it must be really heavy, hence the fuel use.
It's sat on the mooring for almost a year now as he can't afford to use it.....