Help with outboard

Thoughts, Ideas and General Questions
TUDORDUMPY
Posts: 5
Joined: Fri Jun 12, 2020 6:32 am

Help with outboard

Post by TUDORDUMPY »

We have an d 1977 Volvo Penta Archimedes 70hp outboard that cam with our boat.

I am quite a novice when it comes to outboards, I have had a tinker and got it running, but my question is about cooling.

I assume this is s full water cooled engine, would the water get pumped out under the water line or above?

I can see a small trickle coming out half way up leg, but not enough to cool this engine.

Any help would be good.

Also would a 20hp outboard push a 536?

Many thanks
535Mustard
Posts: 177
Joined: Sun Dec 29, 2019 11:07 am

Re: Help with outboard

Post by 535Mustard »

I seem to remember that at least some of the Volvo Penta achemedies engines were actually air cooled on the engine and water cooled in the gearbox only and the small trickle of water you see is all you get as it doesn't go all the way up to the engine itself.
I might be wrong though lol.

As for a 20hp, yes that's plenty for a 536 for river/inland use.

Tom
dellquay13
Posts: 556
Joined: Tue Mar 15, 2011 7:45 am
Location: Pequod, F4 mk4, Milford Haven Marina

Re: Help with outboard

Post by dellquay13 »

Hi,
Are you using your boat inland or at sea? It's unusual for an inland boat to have such a big outboard unless it pulls skiers or toys.
I don't know much about volvo penta archimedes motors, other than their age, but I wouldn't have any confidence in the reliability of a 40 year old engine, from experience of constant problems with old Johnson and Mercury engines in the 40-90hp range. I personally wouldn't risk one at sea again, even with a good auxilliary outboard. It's no fun limping back to shore with a 5hp and an early finish to the day when you should be enjoying the full use of your boat.
A 20hp will push a 536 at about 6-7mph maximum, and the more you rev, the bigger the bow wave you will push around in front of you with no increase in speed, but it has plenty of power for inland waters and enough power to be happy pottering around against a tide at sea. It will never be zippy though, you need at least 50hp for that, and better with a reliable 70hp.
I have now sold my 1989 F4 mk4, 2015 70hp 4str Yamaha. Milford Haven. I proudly owned it for over 20 years, before changing to sailpower and a yacht...
DACS
Posts: 77
Joined: Sat Jul 19, 2014 9:59 am

Re: Help with outboard

Post by DACS »

Most outboards over about 4 hp are water cooled and your 70 hp certainly is. Almost all engines follow a similar design so your is probably like this.

There is a pump just above the gearbox which takes in water and pumps it up a tube into the cooling passages around the cylinders. There is usually a thermostat on larger engines to divert the flow to allow the engine to warm up quickly from cold. Once the water has been circulated it is dumped into the exhaust. This cools the exhaust gases and also condenses the water vapour, reducing the volume of gas and reducing back pressure. The mixture of water and exhaust gases is discharges underwater behind or through the centre of the propeller.

Many engines divert a small amount of water through a nozzle just below the engine and this is what you have seen. It is known as a tell-tale and helps to show you the the water pump is working. It is important to check this as the pumps use a neoprene impeller which can be destroyed by running dry, silt and sand in the water or old age. If the pump fails then the engine will quickly overheat and probably seize up.
535Mustard
Posts: 177
Joined: Sun Dec 29, 2019 11:07 am

Re: Help with outboard

Post by 535Mustard »

https://youtu.be/KnY50bAobdI

This video seems to show how the water tell tail should be on the achemedies 700 outboard.
TUDORDUMPY
Posts: 5
Joined: Fri Jun 12, 2020 6:32 am

Re: Help with outboard

Post by TUDORDUMPY »

Thank you for all your help.

I will go and run the engine again this evening.