Trolling engine
-
Clive
- Posts: 548
- Joined: Sun Jun 23, 2019 8:41 am
Trolling engine
Hi. We have a 35hp engine on our 4+2 which runs on river/canal at about 1500 revs. When nearly back today the engine went lumpy and would then pick up revs but then drop back. It also started stalling if left ticking over. As this will be ongoing use does anyone have any tricks to keep engine happy? No we can’t afford a new smaller engine and when we start fair weather coastal work the engine will be. Cheers
4+2 (1988) 35hp Honda outboard, currently in a field outside Horsham.
-
daveflack
- Posts: 291
- Joined: Fri Nov 08, 2013 6:54 pm
- Location: Black Hawk "Atlast"Ullswater, now a 4+2
Re: Trolling engine
Hi Clive, you don't say which fuel your engine is using, ie 4 or 2 stroke, 2 strokes don't like low revs as spark plugs start to oil up, they need to be "working". I have a similar sized honda 4str which will run happily at tickover/low revs but is reluctant to accelerate if the throttle is moved to quickly, it's a common issue apparently. As a precaution just make sure your fuel lines are not kinked or perished (allowing air into lines) check any fuel filters are clean & make sure tank breather is open. Cheers magic
-
Clive
- Posts: 548
- Joined: Sun Jun 23, 2019 8:41 am
Re: Trolling engine
Hi Dave - it's 4 stroke, 3 cylinder. These engines though old, will run on the new E10 petrol so that might have an impact. Also the higher octane unleaded might help. My first step will be to check the plugs and get some designed for low rev use. The ones in there have only done 15 hours max so plenty of life in them and I cleaned them before I went out. I can easily swap plugs for different use.
Mine seems to like a quick stab of the throttle which I sometimes have to do mooring in tight spaces! The fuel lines and primer are new and breather open so I'm hoping it's plugs.
Mine seems to like a quick stab of the throttle which I sometimes have to do mooring in tight spaces! The fuel lines and primer are new and breather open so I'm hoping it's plugs.
4+2 (1988) 35hp Honda outboard, currently in a field outside Horsham.
-
dellquay13
- Posts: 556
- Joined: Tue Mar 15, 2011 7:45 am
- Location: Pequod, F4 mk4, Milford Haven Marina
Re: Trolling engine
Hi Clive,
This does sound like a fuel issue, blocked idle jets, overchoking or stale low grade petrol can all cause this.
Try putting a good glug of fuel system cleaner into some fresh 97 grade petrol, and find somewhere you can give it an Italian tune-up at full revs. If that isn't possible where you are, clean out as much of the system as you can.
Is your engine carburetor or injected? Check the choke isn't sticking on. Injectors don't use a choke, but they do inject very rich until the engine warms up. Check you're getting full airflow, that can work like a stuck choke if you're not getting enough air in.
If you're cash rich and time poor, get it serviced and save the rest of the boating season. Time afloat is precious.
Chris
This does sound like a fuel issue, blocked idle jets, overchoking or stale low grade petrol can all cause this.
Try putting a good glug of fuel system cleaner into some fresh 97 grade petrol, and find somewhere you can give it an Italian tune-up at full revs. If that isn't possible where you are, clean out as much of the system as you can.
Is your engine carburetor or injected? Check the choke isn't sticking on. Injectors don't use a choke, but they do inject very rich until the engine warms up. Check you're getting full airflow, that can work like a stuck choke if you're not getting enough air in.
If you're cash rich and time poor, get it serviced and save the rest of the boating season. Time afloat is precious.
Chris
I have now sold my 1989 F4 mk4, 2015 70hp 4str Yamaha. Milford Haven. I proudly owned it for over 20 years, before changing to sailpower and a yacht...
-
Clive
- Posts: 548
- Joined: Sun Jun 23, 2019 8:41 am
Re: Trolling engine
Hi Chris
Bearing in mind that apart from 10 minutes checking the telltale in a tub with no prop after I replaced the impeller and cleaned out the cooling system, this was the first outing since Oct 2019 when I drained the carbs - and replaced the fuel lines this year so no stale fuel involved - I always use 'Fuel Set' as an additive. It started 2nd turn after all that time and had no issues for 2 hours. It was on our return for the last hour it started. Choke working fine.
I did full revs on an open bit of the canal for a few seconds only gave me a tad over 3000rpm but perfect running, I have a new trolling prop fitted (11.4x12HQ).
The outings we did in the old world (pre Cover) were for 5-6 hours with no issues at all so I suspect a carb clean (never done before) and fresh plugs is the next thing. The engine hours read 3500 when I replaced it!!! Think it's the original engine. Just had a look at the plugs and they wouldn't flag up a warning if all was good so possibly jets need a clean.
Bearing in mind that apart from 10 minutes checking the telltale in a tub with no prop after I replaced the impeller and cleaned out the cooling system, this was the first outing since Oct 2019 when I drained the carbs - and replaced the fuel lines this year so no stale fuel involved - I always use 'Fuel Set' as an additive. It started 2nd turn after all that time and had no issues for 2 hours. It was on our return for the last hour it started. Choke working fine.
I did full revs on an open bit of the canal for a few seconds only gave me a tad over 3000rpm but perfect running, I have a new trolling prop fitted (11.4x12HQ).
The outings we did in the old world (pre Cover) were for 5-6 hours with no issues at all so I suspect a carb clean (never done before) and fresh plugs is the next thing. The engine hours read 3500 when I replaced it!!! Think it's the original engine. Just had a look at the plugs and they wouldn't flag up a warning if all was good so possibly jets need a clean.
4+2 (1988) 35hp Honda outboard, currently in a field outside Horsham.
-
dellquay13
- Posts: 556
- Joined: Tue Mar 15, 2011 7:45 am
- Location: Pequod, F4 mk4, Milford Haven Marina
Re: Trolling engine
If the problem happened suddenly on your first trip out after a long break, I'd go for the carb clean first, looking at the idle jet closely. Maybe replace the fuel filter, and check the tank for debris.
I've got a big fuel filter and water trap drain with a sight bowl in my fuel line before my primer bulb, as well as the little one under the cowling. It's bolted to the splashwell.
I've got a big fuel filter and water trap drain with a sight bowl in my fuel line before my primer bulb, as well as the little one under the cowling. It's bolted to the splashwell.
I have now sold my 1989 F4 mk4, 2015 70hp 4str Yamaha. Milford Haven. I proudly owned it for over 20 years, before changing to sailpower and a yacht...
-
Clive
- Posts: 548
- Joined: Sun Jun 23, 2019 8:41 am
Re: Trolling engine
Yes, I've been thinking an inline filter would be a good idea - what did you get? There a few to choose from and wildly differing prices! Each carb has an idle jet with a default setting. Fuel filter not replaced so I'll do that. The issue started after three hours and came and went over the next hour which was odd, it sounded lumpy like it was intermittently missfiring on one cylinder. That said, it's not reflected in the state of the spark plugs which are the same so I think it's a fuel supply issue.
4+2 (1988) 35hp Honda outboard, currently in a field outside Horsham.
-
dellquay13
- Posts: 556
- Joined: Tue Mar 15, 2011 7:45 am
- Location: Pequod, F4 mk4, Milford Haven Marina
Re: Trolling engine
Blimey! I would have gone loopy if I hadn't been afloat in nearly 2 years. You have more patience than me
I have now sold my 1989 F4 mk4, 2015 70hp 4str Yamaha. Milford Haven. I proudly owned it for over 20 years, before changing to sailpower and a yacht...
-
dellquay13
- Posts: 556
- Joined: Tue Mar 15, 2011 7:45 am
- Location: Pequod, F4 mk4, Milford Haven Marina
Re: Trolling engine
My filter is a Yamaha one fitted by the dealer when they fitted the outboard, a water trap was a necessary condition for the outboard warranty. It's generic looking, and about 6" tall, with a drain off screw at the bottom of the clear sight bowl. I've got a similar but very expensive raccor cartridge one on the diesel line on my other boat.
I have now sold my 1989 F4 mk4, 2015 70hp 4str Yamaha. Milford Haven. I proudly owned it for over 20 years, before changing to sailpower and a yacht...
-
dellquay13
- Posts: 556
- Joined: Tue Mar 15, 2011 7:45 am
- Location: Pequod, F4 mk4, Milford Haven Marina
Re: Trolling engine
If it was like a misfire, you could check the condition of the spark system too, dirty, cracked or loose ht leads, tight cable connections to your CDIs etc.
I have now sold my 1989 F4 mk4, 2015 70hp 4str Yamaha. Milford Haven. I proudly owned it for over 20 years, before changing to sailpower and a yacht...