Suzuki outboard advice

Thoughts, Ideas and General Questions
THEDAMMAN
Posts: 27
Joined: Mon Jul 25, 2011 6:28 pm
Location: KIELDER NORTHUMBERLAND

Suzuki outboard advice

Post by THEDAMMAN »

Hi there I have a Suzuki DT60 2stroke outboard on my Shetland black hawk it’s blown a gasket on the exhaust water jacket cover and I've snapped 2 bolts trying to get the cover off, I’ve asked a couple of marine engineers about fixing it and they have advised that I should scrap it.
I was just going to put the boat up for sale when this happened so I’m gutted as you can imagine.
Is this a job that I can get fixed or do I try to find another outboard?
Mine has electric start and power trim/tilt so I’d have to find something that would fit.
Any suggestions greatly appreciated
vreagh
Posts: 327
Joined: Sat Aug 02, 2014 5:46 pm
Location: Cornwall

Re: Suzuki outboard advice

Post by vreagh »

I would have thought that any garage mechanic would have the tools and knowledge to do this job. I don't know your particular engine, but generally all you need is to centre punch the broken studs to centre up a tapping sized drill bit and afterwards tap the hole to the original thread and replace the bolts.
THEDAMMAN
Posts: 27
Joined: Mon Jul 25, 2011 6:28 pm
Location: KIELDER NORTHUMBERLAND

Re: Suzuki outboard advice

Post by THEDAMMAN »

Thanks for your input,one of the problems is the lower shroud where the top engine cover sits on is blocking access to the bolts as they are behind it and I think that you would have to remove the power head to get to the studs to be able to drill them out.
I think it’s too big of a job to do with the engine in place and at the door.
blebrocq
Posts: 108
Joined: Thu Oct 20, 2022 11:24 am

Re: Suzuki outboard advice

Post by blebrocq »

Tricky one, why not sell the boat as is (explaining about the engine) & accept a drop in price. To get someone else to fix it sounds expensive.
Bob