Hi everyone.
On the platform of my 4+2 there is a circular what looks like an inspection hatch which is screwed down by about six screws. Does anybody have an idea of what is for?
Thanks for reading
David
4+2 bathing platform
-
daveflack
- Posts: 291
- Joined: Fri Nov 08, 2013 6:54 pm
- Location: Black Hawk "Atlast"Ullswater, now a 4+2
Re: 4+2 bathing platform
Hi David, dead simple this one, it's to allow access to the mounting bolts for the outboard motors, as an add on, keep your eye on it coz IT WILL FILL with water !!!! condensation,rain, general seepage & it's surprising how much water it will contain, it can alter the trim a little so pump it out regularly. cheers magic.
-
Davidcapon
- Posts: 4
- Joined: Wed Oct 05, 2022 3:50 pm
Re: 4+2 bathing platform
That’s great thank you. I’ll have a look in side and see if it is full of water. It Does looks a little low at the back.
Thanks again David
Thanks again David
-
blebrocq
- Posts: 108
- Joined: Thu Oct 20, 2022 11:24 am
Re: 4+2 bathing platform
Interesting. I have the same, but the outboard mountings are open to the air, not inside the cavity which is under the circular hatch.
I have never taken mine off, perhaps I should !
Not my boat, but mine is like this one Bob
I have never taken mine off, perhaps I should !
Not my boat, but mine is like this one Bob
You do not have the required permissions to view the files attached to this post.
-
daveflack
- Posts: 291
- Joined: Fri Nov 08, 2013 6:54 pm
- Location: Black Hawk "Atlast"Ullswater, now a 4+2
Re: 4+2 bathing platform
Hi again, the well in the top of the box allows the motor mount to go over the transom, some engines are secured with 4 bolts, the top 2 will pass thro the transom & show in the little well, the lower 2 will go thro the transom BUT the nuts are screwed on from INSIDE the box, hence the circular access hole. cheers magic.
-
blebrocq
- Posts: 108
- Joined: Thu Oct 20, 2022 11:24 am
Re: 4+2 bathing platform
That makes sense.
Cheers
Bob
Cheers
Bob