Hi all, I'm new to the site. I've just bought a shetland 460, plate number 263. I knew it needed work prior to buying and I want to get my hands dirty. As per title the transom is rotten, and I think the buoyancy foam under the deck is soaking wet. Ive started to remove the transom. The box part of the transom is 18mm marine ply which I don't think I'll have too much of a problem with. The wood glassed in at the hull (where outboard clamps too), measures 27mm thickness. So I thought maybe to replace that by using 3 x 9mm marine plywood to glass in?
My main concern is the deck and where to cut and how to go about repairing it... do i use foam and replace like for like? Or do I go down the play pit ball/empty plastic bottle route? Where do I cut? Do I reuse the original deck or am I completely glassing in some marine ply?
Shetland 460 rotten transom, and can hear a squelch when you walk on deck.
-
TheMarketMech
- Posts: 2
- Joined: Mon Jun 10, 2024 11:48 am
-
TheMarketMech
- Posts: 2
- Joined: Mon Jun 10, 2024 11:48 am
Re: Shetland 460 rotten transom, and can hear a squelch when you walk on deck.
Sorry I don't know how to post pictures on here. The boat is at my home, so I'm readily available to pictures of the boat. Thanks.
-
dellquay13
- Posts: 556
- Joined: Tue Mar 15, 2011 7:45 am
- Location: Pequod, F4 mk4, Milford Haven Marina
Re: Shetland 460 rotten transom, and can hear a squelch when you walk on deck.
Membership and the one off £5 fee allows you to post pictures.
Replacing the deck isn’t difficult, the foam underneath doesn’t usually get too full of water, digging down to the bottom of it at the stern lets you get any water out.
The deck is normally 1/2” ply glassed in, which sits flat on top of the foam and is usually quite sturdy, the squelchy spongy flex is just the grp deck detached from the rotten ply below. Before you fit the new ply, if you seal both sides of the new ply with epoxy before fitting, it lasts longer. A few layers of woven matting glassed in and a top flowcoat sees the job done.
Replacing the deck isn’t difficult, the foam underneath doesn’t usually get too full of water, digging down to the bottom of it at the stern lets you get any water out.
The deck is normally 1/2” ply glassed in, which sits flat on top of the foam and is usually quite sturdy, the squelchy spongy flex is just the grp deck detached from the rotten ply below. Before you fit the new ply, if you seal both sides of the new ply with epoxy before fitting, it lasts longer. A few layers of woven matting glassed in and a top flowcoat sees the job done.
I have now sold my 1989 F4 mk4, 2015 70hp 4str Yamaha. Milford Haven. I proudly owned it for over 20 years, before changing to sailpower and a yacht...