Hi all,
I replaced the cable steering system last summer with a new ultraflex cable steering system I bought from a local outboard mechanic (huge difference after I installed it compared to the old steering so that was great).
I've had the boat in and out of the sea (it was in for 5 months in a marina over the last year). I have to admit I haven't done any real checking of the steering since I installed it but this weekend my son had the boat in an inland waterway and found that the steering had seized close to the engine. (Actually he did un-seize it with a few hours of on-site dismantling and bashing but I think maybe the end of the cable at the steering box might be a bit munched now from a lot of force on the steering wheel).
Because our Shedland is a first/early version '80s model the engine has the bucket in the transom coming into the cockpit (I do envy the newer family four with swimdeck type outboard mounting giving you more useable space inside and avoiding the funny steering setup). Because of the "bucket" I have a funny tube on a ball at sticks out of the side of the engine bucket (there is probably a better word for this area of the boat). The funny pivoting tube is necessary because the bucket isn't wide enough to allow for the normal steering arm that goes through the tube on the outboard. This tube thing it where it seized I think.
I've often wondered if a hydraulic steering system would fit - some kits are not every expensive for a smaller <=90HP kit (Vevor is one seller who I've never purchased from but you can't help seeing their ads).
It looks like the hydraulic left and right "arms" don't need the same kind of space that a cable steering arm would use.
I'm wondering if anyone here has any real-life experience trying to fit a hydraulic steering ram onto an outboard on an old family four ?
I'm sure some people will say "why bother" but I know the hydraulic systems have less friction and if they are not that expensive then, for a DIY weekend job, why not consider it?
all the best,
Derek
80's family four - hydraulic steering - will it fit?
-
dconnx
- Posts: 31
- Joined: Thu May 18, 2023 8:27 am
-
dconnx
- Posts: 31
- Joined: Thu May 18, 2023 8:27 am
Re: 80's family four - hydraulic steering - will it fit?
On further consideration - I think the Hydraulic steering systems use exactly the same outboard engine 90 degree arm for the tube-pipe-to-engine steering. So that means it'll be exactly the same amount of space required (just thinking of turning starboard which means the arm will be fully extende). I don't think it can fit and really the funny "tube with ball" mechanism might be the only choice for now.
Derek
Derek