I posted last week asking about a 535 with 25hp yam. I have bought the boat but not the engine. Wanted something a bit newer and more reliable as the kids will be on the boat with me.
I have just bought a 40hp Yamaha (1999) that was on a ferry rescue boat and has hardly seen the water. It has all remotes and been well looked after. The only additional item I need to buy is the cables for throttle/gear. Can anyone tell me the length of cables needed as the shop will supply and fit but needs lengths. The steering is on the bulk head (like most 535's I've seen). Do I just measure from the steering to transom and double the length from transom to engine? I remember from the past there's a formula?
I've tried to upload pictures but don't seem to have permission....Pleased as punch with the new boat
I am new to the Shetland club, having recently purchased a 535! I to am looking for an outboard and have a number of questions relating to DIY but can't seem to create a new post! I'd also like to upload some photos, but can't. Have you had any problems with this?
Certain areas of the site are locked to paid memebers only. This is to stop commercial advertising and scamming and a million viagra adverts from Poland
Life membership is £5 and more details can be found on the JOIN US page
Just got the boat back home and there seems to be a hole drilled in the well at the stern through the keel. It doesen't have a transome bung so I think it must be for drainage? It's about 8mm in diameter. Is that an unusual place? Should I aim to fill it in or buy a transome bung and put it there (through the hull and keel) instead of drilling a new hole in the transome? The only problem I can think of is if the boat ever touches the bottom?
I have a 535 but no drainage bung or holes, might have been before I got the boat as there seems to be a patch over where the bung used to be.
I don't like any holes in boats when they are under water so I personaly would fill your hole, which does seem an odd place to have one, and fit an electric bilge pump. Any water collected in the bottom should normally be splashes or rain water so there should not be much to worry about.
If you keep the boat on water I would suggest an automatic bilge pump just in case you are unable to get to the boat on a regular basis. If it is on a trailer then a sponge works well for soaking up any residue.