Hi all
I've got a Volvo 280 sterndrive fitted to my Shetland 'Black Prince', and it goes up and down no problem with the engine in neutral.
However, when the prop. is turning, I cannot raise it to trim the boat; and if I start it slightly raised and then put on the power, it goes back down to the lowest position causing a 'Bows Down' trim.
Consiquently, I cannot get her up on the plane.
Could I have a leaky hydraulic system ?
Any ideas please
Neil
Volvo 280 Trim
-
dpaulod1
Re: Volvo 280 Trim
Hi There,
I also have a black prince and I use the trim tabs to get the boat onto the plane, usually at about a 45 degree down angle once speed is up to about 18 knots and the boat plains off. I have never tilted the leg for that reason. Hope this helps.
Paul.
I also have a black prince and I use the trim tabs to get the boat onto the plane, usually at about a 45 degree down angle once speed is up to about 18 knots and the boat plains off. I have never tilted the leg for that reason. Hope this helps.
Paul.