leak when rains through were hull and decks join

Thoughts, Ideas and General Questions
riverlee
Posts: 13
Joined: Thu Jun 14, 2012 1:36 pm
Location: colchester

leak when rains through were hull and decks join

Post by riverlee »

hi has anyone else had problem of water getting in rear both sides look like it comes theough the fibre glass were it joins behind rubber rubbing strike can i just re fibre glass over when dry? also were to get new bit rubber to cover the join?
deeandmartin
Posts: 99
Joined: Sat Feb 26, 2011 12:42 pm
Location: No boat at present based in Mid Wales

Re: leak when rains through were hull and decks join

Post by deeandmartin »

when we replaced our 535 and 570 fender strip we filled all around the "lips" underneath where the top and bottom meet with mastic, basically fill any holes and gaps that you can see. Fender strip was purchased from Wilkes Rubber, double check on previous posts as there are several and you need to get the right one for your boat, when fitting if you can use something like a wheeley bin, fill it with as hot water as you can and put the rubber strip in to it to soften up then gently ease it over the two lips, don't pull it too tight nor leave it too slack as if it is too tight when it contracts it will shrink back, and if it is too slack it will not stay in place! Good luck, Dee
riverlee
Posts: 13
Joined: Thu Jun 14, 2012 1:36 pm
Location: colchester

Re: leak when rains through were hull and decks join

Post by riverlee »

thanks for the info was yours fibreglassed over join on the inside? was wondering could i just fibre glass over again?
deeandmartin
Posts: 99
Joined: Sat Feb 26, 2011 12:42 pm
Location: No boat at present based in Mid Wales

Re: leak when rains through were hull and decks join

Post by deeandmartin »

there was no visible split to be seen on the inside, the only visible sign of the lower and topside lip was on the exterior under where the fender strip had been!
riverlee
Posts: 13
Joined: Thu Jun 14, 2012 1:36 pm
Location: colchester

Re: leak when rains through were hull and decks join

Post by riverlee »

thats it but when i rained hard i watched and water seaped through the fibre glass were they seal over the seam
deeandmartin
Posts: 99
Joined: Sat Feb 26, 2011 12:42 pm
Location: No boat at present based in Mid Wales

Re: leak when rains through were hull and decks join

Post by deeandmartin »

I think my first course of action would be to buy a large bottle of Captain Tullys Creaping Crack Cure, squirt it it all around the seam on the outside and then mastic the seam within an inch of its life!!! :)
dellquay13guest

Re: leak when rains through were hull and decks join

Post by dellquay13guest »

Hi,
My F4 had the exact same problem, i took the fendering off, went round with the silicone sealant filling the gap between the topsides and hull and then replaced all the broken rivets with stainless nuts and bolts... Yes, most shetlands seem to be only held together by rusty rivets, but they never come apart. I would never try glassing the inside of the topside/hull joint, as any water is already in by that stage, and it just appears somewhere else instead.

Hope this helps,

Chris