sheltie keelband

Thoughts, Ideas and General Questions
rodey
Posts: 37
Joined: Sun Sep 02, 2012 1:35 pm

sheltie keelband

Post by rodey »

anyone ever fit a s/steel keelband to a sheltie.
hase the keel got timber running the lenght of it to screw into.
cheers
sparky
Posts: 1
Joined: Mon Sep 24, 2012 7:41 pm

Re: sheltie keelband

Post by sparky »

:) hi fella. Fitted a Keel Band to my Sheltie last year. Unfortunatly, theres no timber to screw to. What i did, was to cut a 10" strip out of the deck, the full length of the boat. Removed the Rep foam, exposing the inside skin of the hull & keel. Drilled through the keel, and attatched the band on with 10mm countersunk bolts, every 20". After sealing up all around the bolts, replaced the foam, then fastened back down the stip of deck that i'd cut out. Then proceeded to re,fibre glass the entire deck area, (2plys) then finished it off with a coat of Flowcoat. It may sound a bit severe to cut up your deck, but it only took one weekend, left no visible scars, cost less than £100 to complete, including the cost of the keel band. Only one thing i would warn of, when drilling through the keel, there seems to be a strip of steel running through the lenght of the boat, just after the gel coat, and the first few mm of glass. A good set of drill bits required, as it is very tough to drill, and the heat soon blunts even quality drill bits. Hope this as been of some use. Good luck :D Regards, Sparky.