Hull insulation

Thoughts, Ideas and General Questions
Deaks
Posts: 71
Joined: Sun Dec 02, 2012 6:31 pm
Location: 'Fortune', Black Hawk, Harrogate

Hull insulation

Post by Deaks »

In a week or three, after painting, I'll be starting to fit out the cabin on my Black Hawk, which is currently stripped bare.
I haven't yet had the boat on the water , let alone spent a night aboard.
So my question is, should I be thermally insulating the hull before I start carpeting, etc?
Or isn't condensation a problem? (I've read a lot about ventilation issues on this board recently).
If anyone else has insulated what did you use?
Thanks in advance,

Deaks.
splashmountain

Re: Hull insulation

Post by splashmountain »

We used lining material (barley velour) from Toomer & Hayter (http://www.toomerandhayter.co.uk/) directly liberally glued onto the GRP hull using their contact adhesive. No problems with condensation to date despite two people spending two weeks living exclusively on the boat in coastal waters every year. Condensation only occurs when the air temperature falls below dewpoint temperature for the air humidity - we keep the cabin reasonably well ventilated, and I think the lining is several degrees warmer than bare GRP in contact with the cold water outside, hence minimal condensation. We don't even get water accumulating under the cabin table socket anymore.
Deaks
Posts: 71
Joined: Sun Dec 02, 2012 6:31 pm
Location: 'Fortune', Black Hawk, Harrogate

Re: Hull insulation

Post by Deaks »

Thanks Splash!
I'd seen the Toomer & Hayter stuff and even took a sample from the boat show.
Pleased to hear it does what it's supposed to.

Deaks