In a week or three, after painting, I'll be starting to fit out the cabin on my Black Hawk, which is currently stripped bare.
I haven't yet had the boat on the water , let alone spent a night aboard.
So my question is, should I be thermally insulating the hull before I start carpeting, etc?
Or isn't condensation a problem? (I've read a lot about ventilation issues on this board recently).
If anyone else has insulated what did you use?
Thanks in advance,
Deaks.
Hull insulation
-
Deaks
- Posts: 71
- Joined: Sun Dec 02, 2012 6:31 pm
- Location: 'Fortune', Black Hawk, Harrogate
-
splashmountain
Re: Hull insulation
We used lining material (barley velour) from Toomer & Hayter (http://www.toomerandhayter.co.uk/) directly liberally glued onto the GRP hull using their contact adhesive. No problems with condensation to date despite two people spending two weeks living exclusively on the boat in coastal waters every year. Condensation only occurs when the air temperature falls below dewpoint temperature for the air humidity - we keep the cabin reasonably well ventilated, and I think the lining is several degrees warmer than bare GRP in contact with the cold water outside, hence minimal condensation. We don't even get water accumulating under the cabin table socket anymore.
-
Deaks
- Posts: 71
- Joined: Sun Dec 02, 2012 6:31 pm
- Location: 'Fortune', Black Hawk, Harrogate
Re: Hull insulation
Thanks Splash!
I'd seen the Toomer & Hayter stuff and even took a sample from the boat show.
Pleased to hear it does what it's supposed to.
Deaks
I'd seen the Toomer & Hayter stuff and even took a sample from the boat show.
Pleased to hear it does what it's supposed to.
Deaks