Canopy Frame - Shetland 2+2
-
DickAldridge
- Posts: 7
- Joined: Wed Jun 10, 2015 8:41 am
Canopy Frame - Shetland 2+2
Hi - I'm looking for a frame (canopy) for my Shetland 2+2 (Check Marine 22) - anyone got one or recommendations? I am probably going to have the canopy custom made locally by Jekylls (about £700) as other makers need the original to take a pattern off - this boat has never been in the water and had no canopy. I really don't want to spend too much on the frame and don't mind a bit of DIY. Need to get the frame fitted before the canopy can be measured. No response from Shetland Boats disappointingly. Thanks. Dick
-
Stokey1964
- Posts: 164
- Joined: Sun Dec 07, 2014 1:54 pm
- Location: Stoke-on-Trent
Re: Canopy Frame - Shetland 2+2
you could make the template for the frame from cheap 22mm waste pipe fittings
then buy the stainless or alloy tube and bend to the same size
I went with 22mm stainless but on hindsite it would be better to go for 25mm and its a lot easier finding a pipe bender with a 25mm former.
these are commonly used by electricians for bending conduit.
If you go for alloy then a plumbers pipe bender in 22mm will be fine.
heres a great source for deck and frame fittings. they do joints, left and right hand threaded ones so you can adjust the tension etc
http://www.makefast.com/acatalog/SPRAYH ... TINGS.html
Simon
then buy the stainless or alloy tube and bend to the same size
I went with 22mm stainless but on hindsite it would be better to go for 25mm and its a lot easier finding a pipe bender with a 25mm former.
these are commonly used by electricians for bending conduit.
If you go for alloy then a plumbers pipe bender in 22mm will be fine.
heres a great source for deck and frame fittings. they do joints, left and right hand threaded ones so you can adjust the tension etc
http://www.makefast.com/acatalog/SPRAYH ... TINGS.html
Simon
Shetland 570 MK 1
Yamaha 90 2006
Yamaha 90 2006
-
DickAldridge
- Posts: 7
- Joined: Wed Jun 10, 2015 8:41 am
Re: Canopy Frame - Shetland 2+2
Thanks Simon - will look at that. Dick
-
malhiggins
- Posts: 68
- Joined: Thu Sep 12, 2013 1:00 pm
Re: Canopy Frame - Shetland 2+2
Here is measurements for the frame of a Family 4 mk 3 but I don't know if it is useful.
Mal
You do not have the required permissions to view the files attached to this post.
-
DickAldridge
- Posts: 7
- Joined: Wed Jun 10, 2015 8:41 am
Re: Canopy Frame - Shetland 2+2
Thanks Mal