Canopy Frame - Shetland 2+2

Missing a vital part? Need to track down a spare? Just ask.
DickAldridge
Posts: 7
Joined: Wed Jun 10, 2015 8:41 am

Canopy Frame - Shetland 2+2

Post by DickAldridge »

Hi - I'm looking for a frame (canopy) for my Shetland 2+2 (Check Marine 22) - anyone got one or recommendations? I am probably going to have the canopy custom made locally by Jekylls (about £700) as other makers need the original to take a pattern off - this boat has never been in the water and had no canopy. I really don't want to spend too much on the frame and don't mind a bit of DIY. Need to get the frame fitted before the canopy can be measured. No response from Shetland Boats disappointingly. Thanks. Dick
Stokey1964
Posts: 164
Joined: Sun Dec 07, 2014 1:54 pm
Location: Stoke-on-Trent

Re: Canopy Frame - Shetland 2+2

Post by Stokey1964 »

you could make the template for the frame from cheap 22mm waste pipe fittings

then buy the stainless or alloy tube and bend to the same size

I went with 22mm stainless but on hindsite it would be better to go for 25mm and its a lot easier finding a pipe bender with a 25mm former.

these are commonly used by electricians for bending conduit.
If you go for alloy then a plumbers pipe bender in 22mm will be fine.

heres a great source for deck and frame fittings. they do joints, left and right hand threaded ones so you can adjust the tension etc

http://www.makefast.com/acatalog/SPRAYH ... TINGS.html



Simon
Shetland 570 MK 1
Yamaha 90 2006
DickAldridge
Posts: 7
Joined: Wed Jun 10, 2015 8:41 am

Re: Canopy Frame - Shetland 2+2

Post by DickAldridge »

Thanks Simon - will look at that. Dick
malhiggins
Posts: 68
Joined: Thu Sep 12, 2013 1:00 pm

Re: Canopy Frame - Shetland 2+2

Post by malhiggins »

pramhood.jpg

Here is measurements for the frame of a Family 4 mk 3 but I don't know if it is useful.

Mal
You do not have the required permissions to view the files attached to this post.
DickAldridge
Posts: 7
Joined: Wed Jun 10, 2015 8:41 am

Re: Canopy Frame - Shetland 2+2

Post by DickAldridge »

Thanks Mal