Forgive me if it all seems a bit obvious.
I've taken tons of photos and will include a few. If anyone has a specific area they'd like photographing please let me know.
Day 1.
Remove rubbing strip.
The strip is held in place with two caps at the stern. One of them, pictured, had two stainless bolts straight through which came out easily. The other had four self tappers which needed drilling out.

Once removed the strip comes off easily. Unsure yet whether to clean up or replace.
Remove two aft cleats.
Dead easy after side panel is removed.
Remove large foredeck cleat.
Not so easy due to extensive corrosion of nuts but doable with patience and penetrating oil. Ratchet for inside cabin and enormous flat-bladed screwdriver for outside.

Remove bow fairleads.
Impossibly corroded nuts within anchor bay. Cut nuts away with small angle grinder and wafer thin cutting blade. Tricky access but OK with a bit of patience.

Anchor hatch.
Dead easy. All bolts came undone after a bit of penetrating oil.

Front grab rail.
A pig to get off. Completely corroded nuts both in the anchor well and in the cabin roof. Resorted to grinding off the nuts in both cases.

Cabin roof handrails.
Also dead easy after penetrating oil.
The cleats and handrail brackets are supposed to be black. Pondering on whether to powder coat or go cheap and cheerful with black smooth Hammerite. I'll decide when I've cleaned up the windscreen surround, which also should be black.

I've also been experimenting with methods of removing the nasty topside paint. Below are the untreated port and chemically stripped starboard rear corners.

The stripper, Owatrol Marine Strip, did a great job and left a dead smooth finish. Took 18 hours though in current temperatures (8-10C). It'll be invaluable on the textured topside walkway surfaces where sanding will be impossible. I think using it for the whole topsides, though, would work out expensive. I'll monitor how far twenty quid's worth goes.
A very therapeutic four hour's work. Family dinner tomorrow so no chance to do much - might get up early and sneak an hour or two. Rear rails and light mast look easy.
Deaks